After a bus reset, we should move our state to Default, in order to be able to re-enumerate again. I only managed to trigger this problem with g_ether by removing the cable after a few transfers had been completed. Cc: stable@xxxxxxxxxxxxxxx Signed-off-by: Felipe Balbi <balbi@xxxxxx> --- This should go to 3.2-stable too. I'll send on 3.3 pull request. drivers/usb/dwc3/gadget.c | 3 +++ 1 files changed, 3 insertions(+), 0 deletions(-) diff --git a/drivers/usb/dwc3/gadget.c b/drivers/usb/dwc3/gadget.c index c92fefa..19c1cfb 100644 --- a/drivers/usb/dwc3/gadget.c +++ b/drivers/usb/dwc3/gadget.c @@ -1713,6 +1713,9 @@ static void dwc3_gadget_reset_interrupt(struct dwc3 *dwc) dwc3_gadget_disconnect_interrupt(dwc); } + /* after reset -> Default State */ + dwc->dev_state = DWC3_DEFAULT_STATE; + /* Enable PHYs */ dwc3_gadget_usb2_phy_power(dwc, true); dwc3_gadget_usb3_phy_power(dwc, true); -- 1.7.8.rc4 -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
