From: Vikram Pandita <vikram.pandita@xxxxxx>
Data Buffer Error as per spec section 4.15.1.1.2
results when there is Underrun or Overrun condition.
This error is considered non-fatal and never gets reported.
Its a very good indication on things going wrong at system level,
like running memory at much slower speed.
This is a good error to flag allowing system level corrections.
An issue was found with OMAP4460 board where DDR had to be run
at full speed and this logging helped.
Signed-off-by: Vikram Pandita <vikram.pandita@xxxxxx>
Reviewed-by: Marek Vasut <marek.vasut@xxxxxxxxx>
Signed-off-by: Vikram Pandita <vikram.pandita@xxxxxx>
---
v1: original patch
v2: fix review comments from Alan Stern
* use usb_endpoint_num, usb_endpoint_dir_in
v3: More comments from Alan Stern
* indent, use qh
drivers/usb/host/ehci-q.c | 11 +++++++++++
1 files changed, 11 insertions(+), 0 deletions(-)
diff --git a/drivers/usb/host/ehci-q.c b/drivers/usb/host/ehci-q.c
index 4e4066c..f136f7f1 100644
--- a/drivers/usb/host/ehci-q.c
+++ b/drivers/usb/host/ehci-q.c
@@ -373,6 +373,17 @@ qh_completions (struct ehci_hcd *ehci, struct ehci_qh *qh)
retry_xacterr:
if ((token & QTD_STS_ACTIVE) == 0) {
+ /* Report Data Buffer Error: non-fatal but useful */
+ if (token & QTD_STS_DBE)
+ ehci_dbg(ehci,
+ "detected DataBufferErr for urb %p ep%d%s len %d, qtd %p [qh %p]\n",
+ urb,
+ usb_endpoint_num(&urb->ep->desc),
+ usb_endpoint_dir_in(&urb->ep->desc) ? "in" : "out",
+ urb->transfer_buffer_length,
+ qtd,
+ qh);
+
/* on STALL, error, and short reads this urb must
* complete and all its qtds must be recycled.
*/
--
1.7.5.4
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
