Hi,
On my BeagleBoard xM, configuring the MUSB controller in Linux to
peripheral mode (i.e. not OTG mode) and using a built-in gadget driver,
the gadget device sometimes does not appear after a software reboot.
I've seen this with both 2.6.32 and 2.6.39 (Angstrom 2008.1 and 2010.x
distros, respectively).
Our own board exhibits the same behaviour. However: configuring the
MUSB controller in u-boot as a device and only booting as far as u-boot
before a software reset, the device always appears. To me this suggests
a MUSB driver issue in Linux (as opposed to, say, PHY initialization).
I checked with a USB analyzer what happens on the bus: when it doesn't
show up there is a reset on the bus when we reboot, but it doesn't
re-enter full speed mode. No SOFs are sent either.
I did a rudimentary check of the OTG registers in the TPS chip (over
i2c) but saw nothing out of the ordinary.
I set musb_debug = 5 in musb_core.c, but no errors are reported.
I haven't looked at the MUSB controller registers yet; that's next.
Any ideas?
Thanks,
Orjan
--
Orjan Friberg
FlatFrog Laboratories AB
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
