Hi Greg,
( $ echo maintainer > /sys/felipe/mode )
as you asked, I have rebuilt the pull request and checked that it merges
on top of the commit I have. If it doesn't work, then it's because I
don't have your most recent objects and we will have to wait until Hera
is back up and running.
Anyway, below is the pull request. A short summary here:
. MUSB now has mode1 DMA enabled for gadgets which set short_not_ok
flag
. Storage gadget doesn't assume anymore block size is aligned to
wMaxPacketSize
. Number of buffers on storage gadget is now selectable from Kconfig
. DWC3 driver now works fine against linux host and MCOP (a pre-silicon
validation platform from TI)
( $ echo vacations > /sys/felipe/mode )
The following changes since commit 55a46269ccedec140e2487a2344e8a247d48b385:
USB: pl2303: remove unreachable code (2011-08-26 11:27:50 -0700)
are available in the git repository at:
git://gitorious.org/usb/usb.git for-next
Alan Stern (1):
USB: gadget: storage: remove alignment assumption
Anand Gadiyar (1):
usb: musb: Enable DMA mode1 RX for transfers without short packets
Dan Carpenter (1):
usb: dwc3: debugfs: add a kfree() on error to dwc3_testmode_open()
Felipe Balbi (33):
usb: dwc3: core: add missing @ for kerneldoc
usb: dwc3: ep0: fix 'transfered' typo
usb: dwc3: gadget: set request dma to invalid when unmapping
usb: dwc3: gadget: improve command completion debug message
usb: dwc3: core: add defines for XferNotReady event on Control EPs
usb: dwc3: add a bounce buffer for control endpoints
usb: dwc3: ep0: add handling for unaligned OUT transfers
usb: dwc3: core: add flag for EP0 direction
usb: dwc3: ep0: simplify EP0 state machine
usb: dwc3: ep0: fix Get Status handling
usb: dwc3: ep0: clear all EP0 flags
usb: dwc3: drop EP0_STALL state
usb: dwc3: core: add ep0_next_event field
usb: dwc3: use ep0_next_event field
usb: dwc3: omap: fix dev_dbg() calls
usb: dwc3: omap: do not enable DMA Disable Clear IRQ
usb: dwc3: omap: use the macro we already have
usb: dwc3: omap: drop DEV_PM_OPS for now
usb: dwc3: omap: distinguish between SW and HW modes
usb: dwc3: add module.h to dwc3-omap.c and core.c
usb: dwc3: omap: change IRQ name to dwc3-omap
usb: dwc3: omap: fix IRQ handling
usb: dwc3: Fix definition of DWC3_GCTL_U2RSTECN
usb: dwc3: define ScaleDown macro helper
usb: dwc3: gadget: fix GCTL programming
usb: dwc3: gadget: drop the useless dma_sync_single* calls
usb: dwc3: ep0: giveback requests on stall_and_restart
usb: dwc3: ep0: introduce ep0_expect_in flag
usb: dwc3: omap: set idle and standby modes
usb: dwc3: gadget: improve debug on link state change
usb: gadget: audio: actually support both speeds
usb: gadget: audio: queue wLength-sized requests
usb: musb: fix build breakage
Peiyu Li (1):
usb: gadget: storage: adapt logic block size to bound block devices
Per Forlin (1):
usb: gadget: storage: make FSG_NUM_BUFFERS variable size
Sebastian Andrzej Siewior (9):
usb: dwc3: gadget: fixing dequeue of TRBs
usb: dwc3: gadget: reset resource index to zero
usb: dwc3: gadget: use TRB type 6 for ISOC transfers
usb: dwc3: gaget: clear DWC3_EP_WILL_SHUTDOWN bit
usb: dwc3: debugfs: remove test mode interface
usb: dwc3: core: move the core check before soft reset
usb: dwc3: gadget: rework the dequeue on RESET & DISCONNECT
usb: dwc3: gadget: replace mdelay with udelay in the busy loop
usb: dwc3: gadget: do not map/unmap ZLP transfers
arch/arm/mach-omap2/Makefile | 11 +-
drivers/usb/dwc3/core.c | 20 +-
drivers/usb/dwc3/core.h | 58 +++--
drivers/usb/dwc3/debugfs.c | 92 -------
drivers/usb/dwc3/dwc3-omap.c | 155 ++++++------
drivers/usb/dwc3/ep0.c | 412 +++++++++++++++++--------------
drivers/usb/dwc3/gadget.c | 141 ++++++-----
drivers/usb/gadget/Kconfig | 16 ++
drivers/usb/gadget/f_audio.c | 15 +-
drivers/usb/gadget/f_mass_storage.c | 153 ++++++------
drivers/usb/gadget/file_storage.c | 142 +++++------
drivers/usb/gadget/storage_common.c | 56 ++++-
drivers/usb/musb/musb_gadget.c | 69 ++++--
include/linux/platform_data/dwc3-omap.h | 47 ++++
14 files changed, 740 insertions(+), 647 deletions(-)
create mode 100644 include/linux/platform_data/dwc3-omap.h
--
balbi
Attachment:
signature.asc
Description: Digital signature
