> > > +Required properties for type = "utmi". These values are > > derived from > > > +characterization by system engineering. > > > + - hssync_start_delay > > > + - idle_wait_delay > > > + - elastic_limit > > > + - term_range_adj > > > + - xcvr_setup > > > + - xcvr_lsfslew > > > + - xcvr_lsrslew > > > > All of these custom properties should be prefixed with "nvidia," to > > avoid namespace collisions. > > Are you saying we should prefix with "nvidia," on ALL of the > properties I've defined for the tegra20-ehci node? Or > specifically those seven that you pointed out? Because I > don't see a difference in terms of "custom"-ality between > say, hssync-start-delay, and the other stuff like phy-type, > mode, power-down-on-bus-suspend, and the reset-gpio and clk > from phy-type=ulpi...unless we're considering stuff like > phy-type to be a standard USB host controller node property. Looking around for precedence, I see that fsl-usb.txt documents a phy-type as well as a dr-mode (though there's still underscores in that document...I assume they will be replaced by hyphens at some point). So I think the tegra2 ehci host driver will mirror that, and use those property names, in which case I assume we don't have a vendor prefix on those. Are "standard" usb host controller properties (those that shouldn't have a vendor prefix) documented anywhere?-- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
