If cable is not connected to peripheral only board when initializing the gadget driver, then runtime pm calls are out-of-sync and the musb cannot idle with omap2430.c. This was noted on Nokia N900 where musb prevented the CPU to be able to enter deeper retention idle state. This was working in 2.6.38 before runtime pm conversions but there musb smart standby/idle modes were configured statically where they are now updated runtime depending on use and cable status. Reason for out-of-sync is that runtime pm is activated in function musb_gadget.c: usb_gadget_probe_driver but suspended only in OTG mode if cable is not connected when initializing. In peripheral only mode this leads to out-of-sync runtime pm since runtime pm remain active and is activated another time in omap2430.c: musb_otg_notifications for VBUS Connect event and thus cannot suspend for VBUS Disconnect event since the use count remains active. Fix this by moving cable status check and pm_runtime_put call in usb_gadget_probe_driver out of is_otg_enabled block. Signed-off-by: Jarkko Nikula <jhnikula@xxxxxxxxx> --- IMHO this is for 2.6.39 as this fixes PM regression on OMAP2+ boards that use musb in peripheral mode. --- drivers/usb/musb/musb_gadget.c | 6 ++---- 1 files changed, 2 insertions(+), 4 deletions(-) diff --git a/drivers/usb/musb/musb_gadget.c b/drivers/usb/musb/musb_gadget.c index 6dfbf9f..f47c201 100644 --- a/drivers/usb/musb/musb_gadget.c +++ b/drivers/usb/musb/musb_gadget.c @@ -1887,11 +1887,9 @@ int usb_gadget_probe_driver(struct usb_gadget_driver *driver, otg_set_vbus(musb->xceiv, 1); hcd->self.uses_pio_for_control = 1; - - if (musb->xceiv->last_event == USB_EVENT_NONE) - pm_runtime_put(musb->controller); - } + if (musb->xceiv->last_event == USB_EVENT_NONE) + pm_runtime_put(musb->controller); return 0; -- 1.7.0.4 -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
