From: Kalliguddi, Hema <hemahk@xxxxxx> OMAP4430 is embedded with UTMI PHY. This PHY does not support the OTG features like ID pin detection and VBUS detection. This function is exported to an external companion chip TWL6030. Software must retrieve the OTG HNP and SRP status from the TWL6030 and configure the bits inside the control module that drive the related USBOTGHS UTMI interface signals. It must also read back the UTMI signals needed to configure the TWL6030 OTG module. Can find more details in the TRM[1]. [1]:http://focus.ti.com/pdfs/wtbu/OMAP4430_ES2.0_Public_TRM_vJ.pdf In OMAP4430 musb driver VBUS and ID notifications are received from the transceiver driver. If the cable/device is connected during boot, notifications from transceiver driver will be missed till musb driver is loaded. Patch to configure the transceiver in the platform_enable/disable functions and enable the vbus in the gadget driver based on the last_event of the otg_transceiver. Signed-off-by: Hema HK <hemahk@xxxxxx> Cc: Felipe Balbi <balbi@xxxxxx> --- [Fixed the comments from Felipe] drivers/usb/musb/musb_gadget.c | 4 +++ drivers/usb/musb/omap2430.c | 49 ++++++++++++++++++++++++++++++++++++----- 2 files changed, 48 insertions(+), 5 deletions(-) -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html Index: linux-2.6/drivers/usb/musb/musb_gadget.c =================================================================== --- linux-2.6.orig/drivers/usb/musb/musb_gadget.c +++ linux-2.6/drivers/usb/musb/musb_gadget.c @@ -1855,6 +1855,10 @@ int usb_gadget_probe_driver(struct usb_g } else { hcd->self.uses_pio_for_control = 1; } + + if ((musb->xceiv->last_event == USB_EVENT_ID) + && musb->xceiv->set_vbus) + otg_set_vbus(musb->xceiv, 1); } } Index: linux-2.6/drivers/usb/musb/omap2430.c =================================================================== --- linux-2.6.orig/drivers/usb/musb/omap2430.c +++ linux-2.6/drivers/usb/musb/omap2430.c @@ -350,16 +350,56 @@ static int omap2430_musb_init(struct mus if (status) DBG(1, "notification register failed\n"); - /* check whether cable is already connected */ - if (musb->xceiv->state ==OTG_STATE_B_IDLE) - musb_otg_notifications(&musb->nb, 1, - musb->xceiv->gadget); - setup_timer(&musb_idle_timer, musb_do_idle, (unsigned long) musb); return 0; } +static void omap2430_musb_enable(struct musb *musb) +{ + u8 devctl; + unsigned long timeout = jiffies + msecs_to_jiffies(1000); + struct device *dev = musb->controller; + struct musb_hdrc_platform_data *pdata = dev->platform_data; + struct omap_musb_board_data *data = pdata->board_data; + + switch (musb->xceiv->last_event) { + + case USB_EVENT_ID: + otg_init(musb->xceiv); + if (data->interface_type == MUSB_INTERFACE_UTMI) { + devctl = musb_readb(musb->mregs, MUSB_DEVCTL); + /* start the session */ + devctl |= MUSB_DEVCTL_SESSION; + musb_writeb(musb->mregs, MUSB_DEVCTL, devctl); + while (musb_readb(musb->mregs, MUSB_DEVCTL) & + MUSB_DEVCTL_BDEVICE) { + cpu_relax(); + + if (time_after(jiffies, timeout)) { + dev_err(musb->controller, + "configured as A device timeout"); + break; + } + } + } + break; + + case USB_EVENT_VBUS: + otg_init(musb->xceiv); + break; + + default: + break; + } +} + +static void omap2430_musb_disable(struct musb *musb) +{ + if (musb->xceiv->last_event) + otg_shutdown(musb->xceiv); +} + static int omap2430_musb_exit(struct musb *musb) { @@ -377,6 +417,9 @@ static const struct musb_platform_ops om .try_idle = omap2430_musb_try_idle, .set_vbus = omap2430_musb_set_vbus, + + .enable = omap2430_musb_enable, + .disable = omap2430_musb_disable, }; static u64 omap2430_dmamask = DMA_BIT_MASK(32); -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
