Hi,
[..]
> > + * We have to override VBUS/ID signals when MUSB is configured into
> the
> > + * host-only mode -- ID pin will float if no cable is connected, so
> the
> > + * controller won't be able to drive VBUS thinking that it's a B-
> device.
> > + * Otherwise, we want to use the OTG mode and enable VBUS
> comparators.
> > + */
> > + devconf2 &= ~CONF2_OTGMODE;
> > +#ifdef CONFIG_USB_MUSB_HOST
> > + devconf2 |= CONF2_FORCE_HOST;
>
> Well, this is only necessary if the board doesn't have pulldown on
> the USB ID signal. On DA830 EVM, rev. of the board A had it, and it got
> removed on the later revisions (presumably it conflicted with OTG
> function?), so this override became necessary. So, make sure this is
> indeed necessary on your board as using the overrides isn't generally
> desirable (they all also override VBUS sensing in addition to ID pin).
Yes, it's not needed for AM3517EVM
-Ajay
>
> > +#else
> > + devconf2 |= CONF2_SESENDEN | CONF2_VBDTCTEN;
> > +#endif
> > +
> > + omap_ctrl_writel(devconf2, AM35XX_CONTROL_DEVCONF2);
> > +
> > + usb_musb_init(&musb_board_data);
> > +}
> > +
> > static const struct ehci_hcd_omap_platform_data ehci_pdata __initconst
> = {
> > .port_mode[0] = EHCI_HCD_OMAP_MODE_PHY,
> > #if defined(CONFIG_PANEL_SHARP_LQ043T1DG01) || \
>
> WBR, Sergei
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
