Add platform init code for the OMAP3 OHCI driver.
Also, mux-mode settings are taken care of depending on the
actual port mode selected
Signed-off-by: Anand Gadiyar <gadiyar@xxxxxx>
---
v2:
- Fix review comments from Felipe and Sergio
- Cover all combinations for mux-mode
- Add a new flag for 3430 es2.x compatibility
-- I've not yet figured out how usb-ehci.c can set this flag
-- so this is left to board files for now
arch/arm/mach-omap2/usb-ehci.c | 155 ++++++++++++++++++++++++++++++++++
arch/arm/plat-omap/include/plat/usb.h | 23 +++++
2 files changed, 178 insertions(+)
Index: linux-2.6/arch/arm/mach-omap2/usb-ehci.c
===================================================================
--- linux-2.6.orig/arch/arm/mach-omap2/usb-ehci.c
+++ linux-2.6/arch/arm/mach-omap2/usb-ehci.c
@@ -236,3 +236,158 @@ void __init usb_ehci_init(const struct e
#endif /* CONFIG_USB_EHCI_HCD */
+#if defined(CONFIG_USB_OHCI_HCD) || defined(CONFIG_USB_OHCI_HCD_MODULE)
+
+static struct resource ohci_resources[] = {
+ {
+ .start = OMAP34XX_OHCI_BASE,
+ .end = OMAP34XX_OHCI_BASE + SZ_1K - 1,
+ .flags = IORESOURCE_MEM,
+ },
+ {
+ .start = OMAP34XX_UHH_CONFIG_BASE,
+ .end = OMAP34XX_UHH_CONFIG_BASE + SZ_1K - 1,
+ .flags = IORESOURCE_MEM,
+ },
+ {
+ .start = OMAP34XX_USBTLL_BASE,
+ .end = OMAP34XX_USBTLL_BASE + SZ_4K - 1,
+ .flags = IORESOURCE_MEM,
+ },
+ { /* general IRQ */
+ .start = INT_34XX_OHCI_IRQ,
+ .flags = IORESOURCE_IRQ,
+ }
+};
+
+static u64 ohci_dmamask = DMA_BIT_MASK(32);;
+
+static struct platform_device ohci_device = {
+ .name = "ohci-omap3",
+ .id = 0,
+ .dev = {
+ .dma_mask = &ohci_dmamask,
+ .coherent_dma_mask = 0xffffffff,
+ },
+ .num_resources = ARRAY_SIZE(ohci_resources),
+ .resource = ohci_resources,
+};
+
+static void setup_ohci_io_mux(const enum ohci_omap3_port_mode *port_mode)
+{
+ switch (port_mode[0]) {
+ case OMAP_OHCI_PORT_MODE_PHY_6PIN_DATSE0:
+ case OMAP_OHCI_PORT_MODE_PHY_6PIN_DPDM:
+ case OMAP_OHCI_PORT_MODE_TLL_6PIN_DATSE0:
+ case OMAP_OHCI_PORT_MODE_TLL_6PIN_DPDM:
+ omap_mux_init_signal("mm1_rxdp",
+ OMAP_PIN_INPUT_PULLDOWN);
+ omap_mux_init_signal("mm1_rxdm",
+ OMAP_PIN_INPUT_PULLDOWN);
+ /* FALLTHROUGH */
+ case OMAP_OHCI_PORT_MODE_PHY_4PIN_DPDM:
+ case OMAP_OHCI_PORT_MODE_TLL_4PIN_DPDM:
+ omap_mux_init_signal("mm1_rxrcv",
+ OMAP_PIN_INPUT_PULLDOWN);
+ /* FALLTHROUGH */
+ case OMAP_OHCI_PORT_MODE_PHY_3PIN_DATSE0:
+ case OMAP_OHCI_PORT_MODE_TLL_3PIN_DATSE0:
+ omap_mux_init_signal("mm1_txen_n", OMAP_PIN_OUTPUT);
+ /* FALLTHROUGH */
+ case OMAP_OHCI_PORT_MODE_TLL_2PIN_DATSE0:
+ case OMAP_OHCI_PORT_MODE_TLL_2PIN_DPDM:
+ omap_mux_init_signal("mm1_txse0",
+ OMAP_PIN_INPUT_PULLDOWN);
+ omap_mux_init_signal("mm1_txdat",
+ OMAP_PIN_INPUT_PULLDOWN);
+ break;
+ case OMAP_OHCI_PORT_MODE_UNUSED:
+ /* FALLTHROUGH */
+ default:
+ break;
+ }
+ switch (port_mode[1]) {
+ case OMAP_OHCI_PORT_MODE_PHY_6PIN_DATSE0:
+ case OMAP_OHCI_PORT_MODE_PHY_6PIN_DPDM:
+ case OMAP_OHCI_PORT_MODE_TLL_6PIN_DATSE0:
+ case OMAP_OHCI_PORT_MODE_TLL_6PIN_DPDM:
+ omap_mux_init_signal("mm2_rxdp",
+ OMAP_PIN_INPUT_PULLDOWN);
+ omap_mux_init_signal("mm2_rxdm",
+ OMAP_PIN_INPUT_PULLDOWN);
+ /* FALLTHROUGH */
+ case OMAP_OHCI_PORT_MODE_PHY_4PIN_DPDM:
+ case OMAP_OHCI_PORT_MODE_TLL_4PIN_DPDM:
+ omap_mux_init_signal("mm2_rxrcv",
+ OMAP_PIN_INPUT_PULLDOWN);
+ /* FALLTHROUGH */
+ case OMAP_OHCI_PORT_MODE_PHY_3PIN_DATSE0:
+ case OMAP_OHCI_PORT_MODE_TLL_3PIN_DATSE0:
+ omap_mux_init_signal("mm2_txen_n", OMAP_PIN_OUTPUT);
+ /* FALLTHROUGH */
+ case OMAP_OHCI_PORT_MODE_TLL_2PIN_DATSE0:
+ case OMAP_OHCI_PORT_MODE_TLL_2PIN_DPDM:
+ omap_mux_init_signal("mm2_txse0",
+ OMAP_PIN_INPUT_PULLDOWN);
+ omap_mux_init_signal("mm2_txdat",
+ OMAP_PIN_INPUT_PULLDOWN);
+ break;
+ case OMAP_OHCI_PORT_MODE_UNUSED:
+ /* FALLTHROUGH */
+ default:
+ break;
+ }
+ switch (port_mode[2]) {
+ case OMAP_OHCI_PORT_MODE_PHY_6PIN_DATSE0:
+ case OMAP_OHCI_PORT_MODE_PHY_6PIN_DPDM:
+ case OMAP_OHCI_PORT_MODE_TLL_6PIN_DATSE0:
+ case OMAP_OHCI_PORT_MODE_TLL_6PIN_DPDM:
+ omap_mux_init_signal("mm3_rxdp",
+ OMAP_PIN_INPUT_PULLDOWN);
+ omap_mux_init_signal("mm3_rxdm",
+ OMAP_PIN_INPUT_PULLDOWN);
+ /* FALLTHROUGH */
+ case OMAP_OHCI_PORT_MODE_PHY_4PIN_DPDM:
+ case OMAP_OHCI_PORT_MODE_TLL_4PIN_DPDM:
+ omap_mux_init_signal("mm3_rxrcv",
+ OMAP_PIN_INPUT_PULLDOWN);
+ /* FALLTHROUGH */
+ case OMAP_OHCI_PORT_MODE_PHY_3PIN_DATSE0:
+ case OMAP_OHCI_PORT_MODE_TLL_3PIN_DATSE0:
+ omap_mux_init_signal("mm3_txen_n", OMAP_PIN_OUTPUT);
+ /* FALLTHROUGH */
+ case OMAP_OHCI_PORT_MODE_TLL_2PIN_DATSE0:
+ case OMAP_OHCI_PORT_MODE_TLL_2PIN_DPDM:
+ omap_mux_init_signal("mm3_txse0",
+ OMAP_PIN_INPUT_PULLDOWN);
+ omap_mux_init_signal("mm3_txdat",
+ OMAP_PIN_INPUT_PULLDOWN);
+ break;
+ case OMAP_OHCI_PORT_MODE_UNUSED:
+ /* FALLTHROUGH */
+ default:
+ break;
+ }
+}
+
+void __init usb_ohci_init(const struct ohci_hcd_omap_platform_data *pdata)
+{
+ platform_device_add_data(&ohci_device, pdata, sizeof(*pdata));
+
+ /* Setup Pin IO MUX for OHCI */
+ if (cpu_is_omap34xx())
+ setup_ohci_io_mux(pdata->port_mode);
+
+ if (platform_device_register(&ohci_device) < 0) {
+ pr_err("Unable to register FS-USB (OHCI) device\n");
+ return;
+ }
+}
+
+#else
+
+void __init usb_ohci_init(const struct ohci_hcd_omap_platform_data *pdata)
+{
+}
+
+#endif /* CONFIG_USB_OHCI_HCD */
Index: linux-2.6/arch/arm/plat-omap/include/plat/usb.h
===================================================================
--- linux-2.6.orig/arch/arm/plat-omap/include/plat/usb.h
+++ linux-2.6/arch/arm/plat-omap/include/plat/usb.h
@@ -13,6 +13,20 @@ enum ehci_hcd_omap_mode {
EHCI_HCD_OMAP_MODE_TLL,
};
+enum ohci_omap3_port_mode {
+ OMAP_OHCI_PORT_MODE_UNUSED,
+ OMAP_OHCI_PORT_MODE_PHY_6PIN_DATSE0,
+ OMAP_OHCI_PORT_MODE_PHY_6PIN_DPDM,
+ OMAP_OHCI_PORT_MODE_PHY_3PIN_DATSE0,
+ OMAP_OHCI_PORT_MODE_PHY_4PIN_DPDM,
+ OMAP_OHCI_PORT_MODE_TLL_6PIN_DATSE0,
+ OMAP_OHCI_PORT_MODE_TLL_6PIN_DPDM,
+ OMAP_OHCI_PORT_MODE_TLL_3PIN_DATSE0,
+ OMAP_OHCI_PORT_MODE_TLL_4PIN_DPDM,
+ OMAP_OHCI_PORT_MODE_TLL_2PIN_DATSE0,
+ OMAP_OHCI_PORT_MODE_TLL_2PIN_DPDM,
+};
+
struct ehci_hcd_omap_platform_data {
enum ehci_hcd_omap_mode port_mode[OMAP3_HS_USB_PORTS];
unsigned phy_reset:1;
@@ -21,6 +35,13 @@ struct ehci_hcd_omap_platform_data {
int reset_gpio_port[OMAP3_HS_USB_PORTS];
};
+struct ohci_hcd_omap_platform_data {
+ enum ohci_omap3_port_mode port_mode[OMAP3_HS_USB_PORTS];
+
+ /* Set this to true for ES2.x silicon */
+ unsigned es2_compatibility:1;
+};
+
/*-------------------------------------------------------------------------*/
#define OMAP1_OTG_BASE 0xfffb0400
@@ -55,6 +76,8 @@ extern void usb_musb_init(struct omap_mu
extern void usb_ehci_init(const struct ehci_hcd_omap_platform_data *pdata);
+extern void usb_ohci_init(const struct ohci_hcd_omap_platform_data *pdata);
+
#endif
void omap_usb_init(struct omap_usb_config *pdata);
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
