From: Cliff Cai <cliff.cai@xxxxxxxxxx>
Rather than hardcoding the gpio levels for vrsel, allow the platform
resources to handle this so boards can be active high or low.
Signed-off-by: Cliff Cai <cliff.cai@xxxxxxxxxx>
Signed-off-by: Mike Frysinger <vapier@xxxxxxxxxx>
Signed-off-by: Felipe Balbi <felipe.balbi@xxxxxxxxx>
---
drivers/usb/musb/blackfin.c | 8 ++++----
include/linux/usb/musb.h | 1 +
2 files changed, 5 insertions(+), 4 deletions(-)
diff --git a/drivers/usb/musb/blackfin.c b/drivers/usb/musb/blackfin.c
index 585b60b..7160959 100644
--- a/drivers/usb/musb/blackfin.c
+++ b/drivers/usb/musb/blackfin.c
@@ -245,10 +245,10 @@ static void bfin_vbus_power(struct musb *musb, int is_on, int sleeping)
static void bfin_set_vbus(struct musb *musb, int is_on)
{
- if (is_on)
- gpio_set_value(musb->config->gpio_vrsel, 1);
- else
- gpio_set_value(musb->config->gpio_vrsel, 0);
+ int value = musb->config->gpio_vrsel_active;
+ if (!is_on)
+ value = !value;
+ gpio_set_value(musb->config->gpio_vrsel, value);
DBG(1, "VBUS %s, devctl %02x "
/* otg %3x conf %08x prcm %08x */ "\n",
diff --git a/include/linux/usb/musb.h b/include/linux/usb/musb.h
index f3d68f6..fbb83fe 100644
--- a/include/linux/usb/musb.h
+++ b/include/linux/usb/musb.h
@@ -88,6 +88,7 @@ struct musb_hdrc_config {
#ifdef CONFIG_BLACKFIN
/* A GPIO controlling VRSEL in Blackfin */
unsigned int gpio_vrsel;
+ unsigned int gpio_vrsel_active;
#endif
};
--
1.7.0.rc0.33.g7c3932
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
