https://bugzilla.kernel.org/show_bug.cgi?id=219824 --- Comment #4 from Artem S. Tashkinov (aros@xxxxxxx) --- This just happened again: [161470.836493] PM: resume devices took 0.547 seconds [161470.836720] OOM killer enabled. [161470.836721] Restarting tasks ... done. [161470.839715] random: crng reseeded on system resumption [161470.845090] PM: suspend exit [161471.322491] cs35l41-hda i2c-CSC3551:00-cs35l41-hda.0: DSP1: Firmware: 400a4 vendor: 0x2 v0.43.1, 2 algorithms [161471.324469] cs35l41-hda i2c-CSC3551:00-cs35l41-hda.0: DSP1: cirrus/cs35l41-dsp1-spk-prot-103c8b72.bin: v0.43.1 [161471.324480] cs35l41-hda i2c-CSC3551:00-cs35l41-hda.0: DSP1: spk-prot: D:\Amp Tuning\HP\840\0930\103C8B45_220930.bin [161471.403951] cs35l41-hda i2c-CSC3551:00-cs35l41-hda.1: Calibration applied: R0=10446 [161471.407392] cs35l41-hda i2c-CSC3551:00-cs35l41-hda.0: Calibration applied: R0=10526 [161471.432157] cs35l41-hda i2c-CSC3551:00-cs35l41-hda.1: Firmware Loaded - Type: spk-prot, Gain: 17 [161471.433916] cs35l41-hda i2c-CSC3551:00-cs35l41-hda.0: Firmware Loaded - Type: spk-prot, Gain: 17 [161471.523827] hp_wmi: Unknown event_id - 131073 - 0x0 [162644.637587] xhci_hcd 0000:c3:00.3: xHCI host not responding to stop endpoint command [162644.651068] xhci_hcd 0000:c3:00.3: xHCI host controller not responding, assume dead [162644.651076] xhci_hcd 0000:c3:00.3: HC died; cleaning up [162644.651099] xhci_hcd 0000:c3:00.3: Timeout while waiting for stop endpoint command [162644.651102] usb 1-2: USB disconnect, device number 4 [162644.678374] usb 1-3: USB disconnect, device number 2 [162644.678748] usb 1-4: USB disconnect, device number 3 Shortly after resume all the USB ports are disabled. I'm reverting back to Linux 6.11. I cannot use my device like this. -- You may reply to this email to add a comment. You are receiving this mail because: You are watching the assignee of the bug.
