On 10/24/2024 08:37, Basavaraj Natikar wrote:
Use pm_runtime_put in the remove function and pm_runtime_get to disable
RPM on platforms that don't support runtime D3, as re-enabling it through
sysfs auto power control may cause the controller to malfunction. This
can lead to issues such as hotplug devices not being detected due to
failed interrupt generation.
Fixes: a5d6264b638e ("xhci: Enable RPM on controllers that support low-power states")
Signed-off-by: Basavaraj Natikar <Basavaraj.Natikar@xxxxxxx>
Cc: stable@xxxxxxxxxxxxxxx
Reviewed-by: Mario Limonciello <mario.limonciello@xxxxxxx>
---
v2->v3:
* Respinned v3 with an updated changelog.
v1->v2:
* Used pm_runtime_get and updated the subject line accordingly.
---
drivers/usb/host/xhci-pci.c | 6 ++++--
1 file changed, 4 insertions(+), 2 deletions(-)
diff --git a/drivers/usb/host/xhci-pci.c b/drivers/usb/host/xhci-pci.c
index 7e538194a0a4..cb07cee9ed0c 100644
--- a/drivers/usb/host/xhci-pci.c
+++ b/drivers/usb/host/xhci-pci.c
@@ -640,7 +640,7 @@ int xhci_pci_common_probe(struct pci_dev *dev, const struct pci_device_id *id)
pm_runtime_put_noidle(&dev->dev);
if (pci_choose_state(dev, PMSG_SUSPEND) == PCI_D0)
- pm_runtime_forbid(&dev->dev);
+ pm_runtime_get(&dev->dev);
else if (xhci->quirks & XHCI_DEFAULT_PM_RUNTIME_ALLOW)
pm_runtime_allow(&dev->dev);
@@ -683,7 +683,9 @@ void xhci_pci_remove(struct pci_dev *dev)
xhci->xhc_state |= XHCI_STATE_REMOVING;
- if (xhci->quirks & XHCI_DEFAULT_PM_RUNTIME_ALLOW)
+ if (pci_choose_state(dev, PMSG_SUSPEND) == PCI_D0)
+ pm_runtime_put(&dev->dev);
+ else if (xhci->quirks & XHCI_DEFAULT_PM_RUNTIME_ALLOW)
pm_runtime_forbid(&dev->dev);
if (xhci->shared_hcd) {
