On 24-10-23 09:52:19, Johan Hovold wrote: > On Wed, Oct 23, 2024 at 10:32:09AM +0300, Abel Vesa wrote: > > On 24-10-23 09:04:10, Johan Hovold wrote: > > > On Tue, Oct 22, 2024 at 12:01:14PM +0300, Abel Vesa wrote: > > > > On 24-10-15 15:03:15, Johan Hovold wrote: > > > > > On Fri, Oct 04, 2024 at 04:57:38PM +0300, Abel Vesa wrote: > > > > > > > > > + ret = ps8830_get_vregs(retimer); > > > > > > + if (ret) > > > > > > + return ret; > > > > > > + > > > > > > + retimer->xo_clk = devm_clk_get(dev, "xo"); > > > > > > + if (IS_ERR(retimer->xo_clk)) > > > > > > + return dev_err_probe(dev, PTR_ERR(retimer->xo_clk), > > > > > > + "failed to get xo clock\n"); > > > > > > + > > > > > > + retimer->reset_gpio = devm_gpiod_get(dev, "reset", GPIOD_OUT_HIGH); > > > > > > > > > > The reset line is active low and should be described as such in DT. So > > > > > here you want to request it as logically low if you want to deassert > > > > > reset. > > > > > > > > This is being reworked in v3 as we need to support cases where the > > > > retimer has been left enabled and initialized by bootloader and we want > > > > to keep that state until unplug event for the cold-plug orientation > > > > to work properly. > > > > > > > > On top of that, we don't want to deassert the reset here. We do that > > > > via gpiod_set_value() call below, after the clocks and regulators have > > > > been enabled. > > > > > > Ok, but you should generally not drive an input high before powering on > > > the device as that can damage the IC (more below). > > > > This is just not true, generally. Think of top level XTALs which feed in > > clocks (and can't be disabled) before ICs are enabled. > > I'm talking about an I/O pin here, you must generally not drive those > high before powering on the IC. > > And AFAIU the same applies to clocks even though the risk of damage > there is lower. As I stated before, enabling (or rather preparing, from kernel's point of view) will definitely glitch due to PLL switcing (unless the mux is glitchless from design). And there is literally no risk of enabling or keeping a clock enabled even if the consumer is powered off. > > > > That is, in this case, you should not deassert reset before making sure > > > the supplies are enabled. > > > > Wrong. Even the data sheet of this retimer shows in the timigs plot the > > reset as being asserted before the supplies are enabled. > > Reset *asserted*, yes (i.e. pull to ground). Not *deasserted* (i.e. > drive high) as you are doing here. Oh, yeah, that has been fixed in v3 already. Also, this v2 version was also wrong from active level point of view. Which is also fixed in v3. > > > And generally speaking, the reset needs to be asserted before the > > supplies are up, so that the IC doesn't start doing any work until > > the SW decides it needs to. > > Again, the problem is that you are *deasserting* reset before enabling > the supplies. Yep. > > Johan
