On Fri, Oct 04, 2024 at 04:57:36PM +0300, Abel Vesa wrote: > The Parade PS8830 is a Type-C multi-protocol retimer that is controlled > via I2C. It provides altmode and orientation handling and usually sits > between the Type-C port and the PHY. > > It is currently used alongside Qualcomm Snapdragon X Elite SoCs on quite > a few laptops already. > > This new driver adds support for the following 3 modes: > - DP 4lanes (pin assignments C and E) > - DP 2lanes + USB3 (pin assignment D) > - USB3 > > This retimer is a LTTPR (Link-Training Tunable PHY Repeater) which means > it can support link training from source to itself. This means that the > DP driver needs to be aware of the repeater presence and to handle > the link training accordingly. This is currently missing from msm dp > driver, but there is already effort going on to add it. Once done, > full external DP will be working on all X1E laptops that make use of > this retimer. I was gonna ask you to include the devicetree changes that enables the retimers as part of this series (to facilitate review and testing), but perhaps you should indeed not post them again until LTTPR support is in place. > Signed-off-by: Abel Vesa <abel.vesa@xxxxxxxxxx> > --- > Changes in v2: > - Addressed all comments from Johan and Konrad. > - Reworked the handling of the vregs so it would be more cleaner. > Dropped the usage of bulk regulators API and handled them separately. > Also discribed all regulators according to data sheet. > - Added all delays according to data sheet. > - Fixed coldplug (on boot) orientation detection. Coldplug orientation detection still does not work here with this series applied. I'm not entirely sure this whether worked better with v1, but with v2 my SuperSpeed ethernet device shows up as a HighSpeed device in one orientation. It is also not disconnected an re-enumerated as SS as is the case on the X13s (and possibly with v1): usb 1-1: new high-speed USB device number 2 using xhci-hcd > - Didn't pick Krzysztof's R-b tag because the bindings changed w.r.t > supplies. > - Link to v1: https://lore.kernel.org/r/20240829-x1e80100-ps8830-v1-0-bcc4790b1d45@xxxxxxxxxx > > --- > Abel Vesa (2): > dt-bindings: usb: Add Parade PS8830 Type-C retimer bindings > usb: typec: Add support for Parade PS8830 Type-C Retimer Johan
