Change pm_runtime_forbid to pm_runtime_disable to disable RPM on platforms that don't support runtime D3, as re-enabling it through sysfs auto power control may cause the controller to malfunction. This can lead to issues such as hotplug devices not being detected due to failed interrupt generation. Fixes: a5d6264b638e ("xhci: Enable RPM on controllers that support low-power states") Suggested-by: Mario Limonciello <mario.limonciello@xxxxxxx> Signed-off-by: Basavaraj Natikar <Basavaraj.Natikar@xxxxxxx> --- drivers/usb/host/xhci-pci.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/drivers/usb/host/xhci-pci.c b/drivers/usb/host/xhci-pci.c index dc1e345ab67e..39ab32fed3f4 100644 --- a/drivers/usb/host/xhci-pci.c +++ b/drivers/usb/host/xhci-pci.c @@ -635,7 +635,7 @@ static int xhci_pci_probe(struct pci_dev *dev, const struct pci_device_id *id) pm_runtime_put_noidle(&dev->dev); if (pci_choose_state(dev, PMSG_SUSPEND) == PCI_D0) - pm_runtime_forbid(&dev->dev); + pm_runtime_disable(&dev->dev); else if (xhci->quirks & XHCI_DEFAULT_PM_RUNTIME_ALLOW) pm_runtime_allow(&dev->dev); -- 2.25.1