Re: [PATCH v3] platform/x86/hp: Avoid spurious wakeup on HP ProOne 440

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Mon, Sep 09, 2024 at 11:05:05AM +0800, Kai-Heng Feng wrote:
> On Fri, Sep 6, 2024 at 10:22 PM Alan Stern <stern@xxxxxxxxxxxxxxxxxxx> wrote:
> >
> > On Fri, Sep 06, 2024 at 01:30:47PM +0800, Kai-Heng Feng wrote:
> > > The HP ProOne 440 has a power saving design that when the display is
> > > off, it also cuts the USB touchscreen device's power off.
> > >
> > > This can cause system early wakeup because cutting the power off the
> > > touchscreen device creates a disconnect event and prevent the system
> > > from suspending:
> >
> > Is the touchscreen device connected directly to the root hub?  If it is
> > then it looks like there's a separate bug here, which needs to be fixed.
> >
> > > [  445.814574] hub 2-0:1.0: hub_suspend
> > > [  445.814652] usb usb2: bus suspend, wakeup 0
> >
> > Since the wakeup flag is set to 0, the root hub should not generate a
> > wakeup request when a port-status-change event happens.
> 
> The disconnect event itself should not generate a wake request, but
> the interrupt itself still needs to be handled.
> 
> >
> > > [  445.824629] xhci_hcd 0000:00:14.0: Port change event, 1-11, id 11, portsc: 0x202a0
> > > [  445.824639] xhci_hcd 0000:00:14.0: resume root hub
> >
> > But it did.  This appears to be a bug in one of the xhci-hcd suspend
> > routines.

I failed to notice before that the suspend message message above is for 
bus 2 whereas the port change event here is on bus 1.  Nevertheless, I 
assume that bus 1 was suspended with wakeup = 0, so the idea is the 
same.

> So should the xhci-hcd delay all interrupt handling after system resume?

It depends on how the hardware works; I don't know the details.  The 
best approach would be: when suspending the root hub with wakeup = 0, 
the driver will tell the hardware not to generate interrupt requests for 
port-change events (and then re-enable those interrupt requests when the 
root hub is resumed, later on).

If that's not possible, another possibility is that the driver could 
handle the interrupt and clear the hardware's port-change status bit but 
then not ask for the root hub to be resumed.  However, this would 
probably be more difficult to get right.

Alan Stern




[Index of Archives]     [Linux Media]     [Linux Input]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [Old Linux USB Devel Archive]

  Powered by Linux