On Tue, Jun 25, 2024 at 05:54:25PM +0300, Dmitry Baryshkov wrote: > The interface between UCSI and the glue driver is very low-level. It > allows reading the UCSI data from any offset (but in reality the UCSI > driver reads only VERSION, CCI an MESSAGE_IN data). All event handling > is to be done by the glue driver (which already resulted in several > similar-but-slightly different implementations). It leaves no place to > optimize the write-read-read sequence for the command execution (which > might be beneficial for some of the drivers), etc. > > The patchseries attempts to restructure the UCSI glue driver interface > in order to provide sensible operations instead of a low-level read / > write calls. > > If this approach is found to be acceptable, I plan to further rework the > command interface, moving reading CCI and MESSAGE_IN to the common > control code, which should simplify driver's implementation and remove > necessity to split quirks between sync_control and read_message_in e.g. > as implemented in the ucsi_ccg.c. > > Note, the series was tested only on the ucsi_glink platforms. Further > testing is appreciated. > > Depends: [1], [2] > > [1] https://lore.kernel.org/linux-usb/20240612124656.2305603-1-fabrice.gasnier@xxxxxxxxxxx/ > > [2] https://lore.kernel.org/linux-usb/20240621-ucsi-yoga-ec-driver-v8-1-e03f3536b8c6@xxxxxxxxxx/ > > Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx> This doesn't apply to my tree at all, can you rebase and add Heikki's review and resend? thanks, greg k-h
