On 05-06-2024 01:06, Thinh Nguyen wrote:
Hi, On Tue, Jun 04, 2024, Mike Looijmans wrote:On 04-06-2024 03:03, Thinh Nguyen wrote:Hi, On Mon, Jun 03, 2024, Mike Looijmans wrote:When disconnecting the USB cable on an LS1028 device, nothing happens in userspace, which keeps thinking everything is still up and running. Turns out that the DWC3 controller only sends DWC3_DEVICE_EVENT_SUSPEND in that case, and not a DWC3_DEVICE_EVENT_DISCONNECT as one would expect. As a result, sysfs attribute "state" remains "configured" until something resets it. Forward the "suspended" state to sysfs, so that the "state" at least changes into "suspended" when one removes the cable, and hence also matches the gadget's state when really suspended.On disconnection, did you see disconnect interrupt? If so, it should transition to USB_STATE_NOATTACHED. This change doesn't seem to directly address your issue. Can you provide the driver tracepoints?The device doesn't issue a disconnect event, I didn't have tracing enabled in the kernel but added some dev_info() calls to determine what was going on. Added this to dwc3_process_event_entry(): dev_info(dwc->dev, "event: 0x%x type=0x%x", event->raw, event->type.type); When disconnecting the cable from the host, I see this: [ 50.841411] dwc3 3110000.usb: event: 0x6084 type=0x42 [ 50.841457] dwc3 3110000.usb: event: 0x4086 type=0x43 [ 50.841494] dwc3 3110000.usb: event: 0x6084 type=0x42 [ 50.841534] dwc3 3110000.usb: event: 0x4086 type=0x43 [ 50.841571] dwc3 3110000.usb: event: 0x4086 type=0x43 [ 52.650990] dwc3 3110000.usb: event: 0x30601 type=0x0 The "0x4086" and "0x6084" messages are endpoint events that occur all the time while connected. The last event is the "suspend" one. After that, total silence. If you need traces, please point me to a description on how to obtain them.Let me know if you run into issues following this instructions to capture the tracepoints: https://docs.kernel.org/driver-api/usb/dwc3.html#required-information
I've attached the traces as a tarball. Hope it survives.At the start, the USB is up and running (and doing ethernet+mass storage). I saved the trace after pulling the USB cable.
-- Mike Looijmans System Expert TOPIC Embedded Products B.V. Materiaalweg 4, 5681 RJ Best The Netherlands T: +31 (0) 499 33 69 69 E: mike.looijmans@xxxxxxxx W: www.topic.nl
Attachment:
dwc3-trace-ls1028.tar.gz
Description: application/gzip