Re: [PATCH] usb: host: Add a quirk for writing ERST in high-low order

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Tue, May 28, 2024 at 02:57:16PM +0900, Daehwan Jung wrote:
> [Synopsys]- The host controller was design to support ERST setting
> during the RUN state. But since there is a limitation in controller
> in supporting separate ERSTBA_HI and ERSTBA_LO programming,
> It is supported when the ERSTBA is programmed in 64bit,
> or in 32 bit mode ERSTBA_HI before ERSTBA_LO
> 
> [Synopsys]- The internal initialization of event ring fetches
> the "Event Ring Segment Table Entry" based on the indication of
> ERSTBA_LO written.
> 
> Signed-off-by: Daehwan Jung <dh10.jung@xxxxxxxxxxx>
> ---
>  drivers/usb/host/xhci-mem.c | 5 ++++-
>  drivers/usb/host/xhci.h     | 2 ++
>  2 files changed, 6 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/usb/host/xhci-mem.c b/drivers/usb/host/xhci-mem.c
> index 3100219..ef768e6 100644
> --- a/drivers/usb/host/xhci-mem.c
> +++ b/drivers/usb/host/xhci-mem.c
> @@ -2325,7 +2325,10 @@ xhci_add_interrupter(struct xhci_hcd *xhci, struct xhci_interrupter *ir,
>  	erst_base = xhci_read_64(xhci, &ir->ir_set->erst_base);
>  	erst_base &= ERST_BASE_RSVDP;
>  	erst_base |= ir->erst.erst_dma_addr & ~ERST_BASE_RSVDP;
> -	xhci_write_64(xhci, erst_base, &ir->ir_set->erst_base);
> +	if (xhci->quirks & XHCI_WRITE_64_HI_LO)
> +		hi_lo_writeq(erst_base, &ir->ir_set->erst_base);
> +	else
> +		xhci_write_64(xhci, erst_base, &ir->ir_set->erst_base);
>  
>  	/* Set the event ring dequeue address of this interrupter */
>  	xhci_set_hc_event_deq(xhci, ir);
> diff --git a/drivers/usb/host/xhci.h b/drivers/usb/host/xhci.h
> index 3041515..8664dd1 100644
> --- a/drivers/usb/host/xhci.h
> +++ b/drivers/usb/host/xhci.h
> @@ -17,6 +17,7 @@
>  #include <linux/kernel.h>
>  #include <linux/usb/hcd.h>
>  #include <linux/io-64-nonatomic-lo-hi.h>
> +#include <linux/io-64-nonatomic-hi-lo.h>
>  
>  /* Code sharing between pci-quirks and xhci hcd */
>  #include	"xhci-ext-caps.h"
> @@ -1627,6 +1628,7 @@ struct xhci_hcd {
>  #define XHCI_RESET_TO_DEFAULT	BIT_ULL(44)
>  #define XHCI_ZHAOXIN_TRB_FETCH	BIT_ULL(45)
>  #define XHCI_ZHAOXIN_HOST	BIT_ULL(46)
> +#define XHCI_WRITE_64_HI_LO	BIT_ULL(47)
>  
>  	unsigned int		num_active_eps;
>  	unsigned int		limit_active_eps;
> -- 
> 2.7.4
> 
> 

Hi,

This is the friendly patch-bot of Greg Kroah-Hartman.  You have sent him
a patch that has triggered this response.  He used to manually respond
to these common problems, but in order to save his sanity (he kept
writing the same thing over and over, yet to different people), I was
created.  Hopefully you will not take offence and will fix the problem
in your patch and resubmit it so that it can be accepted into the Linux
kernel tree.

You are receiving this message because of the following common error(s)
as indicated below:

- This looks like a new version of a previously submitted patch, but you
  did not list below the --- line any changes from the previous version.
  Please read the section entitled "The canonical patch format" in the
  kernel file, Documentation/process/submitting-patches.rst for what
  needs to be done here to properly describe this.

If you wish to discuss this problem further, or you have questions about
how to resolve this issue, please feel free to respond to this email and
Greg will reply once he has dug out from the pending patches received
from other developers.

thanks,

greg k-h's patch email bot




[Index of Archives]     [Linux Media]     [Linux Input]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [Old Linux USB Devel Archive]

  Powered by Linux