On Tue, May 21, 2024 at 10:15:28AM +0200, Gia wrote: > Here you go: > > 0x0080 0x003c01c0 0b00000000 00111100 00000001 11000000 .... LANE_ADP_CS_0 > [00:07] 0xc0 Next Capability Pointer > [08:15] 0x1 Capability ID > [16:19] 0xc Supported Link Speeds > [20:21] 0x3 Supported Link Widths (SLW) > [22:23] 0x0 Gen 4 Asymmetric Support (G4AS) > [26:26] 0x0 CL0s Support > [27:27] 0x0 CL1 Support > [28:28] 0x0 CL2 Support > 0x0081 0x0828003c 0b00001000 00101000 00000000 00111100 .... LANE_ADP_CS_1 > [00:03] 0xc Target Link Speed → Router shall attempt Gen 3 speed > [04:05] 0x3 Target Link Width → Establish a Symmetric Link > [06:07] 0x0 Target Asymmetric Link → Establish Symmetric Link > [10:10] 0x0 CL0s Enable > [11:11] 0x0 CL1 Enable > [12:12] 0x0 CL2 Enable > [14:14] 0x0 Lane Disable (LD) > [15:15] 0x0 Lane Bonding (LB) > [16:19] 0x8 Current Link Speed → Gen 2 > [20:25] 0x2 Negotiated Link Width → Symmetric Link (x2) > [26:29] 0x2 Adapter State → CL0 > [30:30] 0x0 PM Secondary (PMS) Thanks this looks fine (although the link is still Gen 2). Can you run the same from the dock upstream port too? # tbdump -r 2 -a 1 -vv -N2 LANE_ADP_CS_0
