The 125MHz and 25MHz clock configurations are done in the initialization
regardless of EEPROM (125MHz is needed for RGMII 1000Mbps operation). After
a lite reset (lan78xx_reset), these contents go back to defaults(all 0, so
no 125MHz or 25MHz clock and no ASD/ADD). Also, after the lite reset, the
LAN7800 enables the ASD/ADD in the absence of EEPROM. There is no such
check for LAN7801.
Signed-off-by: Rengarajan S <rengarajan.s@xxxxxxxxxxxxx>
---
drivers/net/usb/lan78xx.c | 7 ++++++-
1 file changed, 6 insertions(+), 1 deletion(-)
diff --git a/drivers/net/usb/lan78xx.c b/drivers/net/usb/lan78xx.c
index ba6c8ac2a736..62dbfff8dad4 100644
--- a/drivers/net/usb/lan78xx.c
+++ b/drivers/net/usb/lan78xx.c
@@ -2944,6 +2944,8 @@ static int lan78xx_reset(struct lan78xx_net *dev)
return ret;
buf |= HW_CFG_MEF_;
+ buf |= HW_CFG_CLK125_EN_;
+ buf |= HW_CFG_REFCLK25_EN_;
ret = lan78xx_write_reg(dev, HW_CFG, buf);
if (ret < 0)
@@ -3032,8 +3034,11 @@ static int lan78xx_reset(struct lan78xx_net *dev)
return ret;
/* LAN7801 only has RGMII mode */
- if (dev->chipid == ID_REV_CHIP_ID_7801_)
+ if (dev->chipid == ID_REV_CHIP_ID_7801_) {
buf &= ~MAC_CR_GMII_EN_;
+ /* Enable Auto Duplex and Auto speed */
+ buf |= MAC_CR_AUTO_DUPLEX_ | MAC_CR_AUTO_SPEED_;
+ }
if (dev->chipid == ID_REV_CHIP_ID_7800_ ||
dev->chipid == ID_REV_CHIP_ID_7850_) {
--
2.25.1
