On Wed, Mar 27, 2024 at 02:24:34PM +0100, Jan Čermák wrote: > Hi Alan, > > On 19. 03. 24 17:03, Alan Stern wrote: > > Change the HUB_DEBOUNCE_TIMEOUT value to 4500, the HUB_DEBOUNCE_STEP > > value to 250 and the HUB_DEBOUNCE_STABLE value to 2000. That just > > might give the device enough time to settle down and start working > > before the computer tries using it. > > sorry for the delay, I only managed to test it today. You are right, with > the timeouts adjusted, it enumerates fine after a while, without any > descriptor read errors or anything like that: > > [ 210.957371] usb 1-1.2: new full-speed USB device number 5 using ehci-pci > [ 211.037728] usb 1-1.2: New USB device found, idVendor=0658, > idProduct=0200, bcdDevice= 0.00 > [ 211.037747] usb 1-1.2: New USB device strings: Mfr=0, Product=0, > SerialNumber=0 > [ 211.039764] cdc_acm 1-1.2:1.0: ttyACM0: USB ACM device Great! > If it's worth anything, usbmon trace is attached below. Anyway, do you have > any ideas what could be done to make it work without doing any detrimental > changes? I was thinking I'll try to reach out to the vendor at this point - > they should be aware their device might stop working with recent kernels, > and they could explain the quirky behavior, or implement any changes on the > firmware side (if it's even possible). The ideal solution would be if the vendor updates the firmware to prevent the device from turning on its pull-up (thereby telling the host computer that it is connected to the bus) until it is ready to operate. There's no good reason to have that > 1-second period during which the device claims to be connected but does not work. Another possible solution, a lot less attractive, would be to change the initialization code in the hub driver so that if it sees the device disconnect itself from the bus, it restarts the entire procedure from the beginning. You'd end up getting a bunch of error messages during the initial non-working period, just as you do now, but afterwards the device should be detected and initialized okay. Alan Stern
