This device is a gray USB parallel port adapter with "F5U002" imprinted
on the plastic and a sticker that says both "F5U002" and "P80453-A".
It's identified in lsusb as "05ab:1001 In-System Design BAYI Printer
Class Support". It's subtly different from the other gray cable I have
that has "F5U002 Rev 2" and "P80453-B" on its sticker and device ID
050d:0002.
The uss720 driver appears to work flawlessly with this device, although
the device evidently does not support ECP.
Signed-off-by: Alex Henrie <alexhenrie24@xxxxxxxxx>
---
drivers/usb/misc/uss720.c | 7 +++++--
1 file changed, 5 insertions(+), 2 deletions(-)
diff --git a/drivers/usb/misc/uss720.c b/drivers/usb/misc/uss720.c
index 32caf3ca300f..5423da08a467 100644
--- a/drivers/usb/misc/uss720.c
+++ b/drivers/usb/misc/uss720.c
@@ -693,7 +693,7 @@ static int uss720_probe(struct usb_interface *intf,
interface = intf->cur_altsetting;
- if (interface->desc.bNumEndpoints < 3) {
+ if (interface->desc.bNumEndpoints < 2) {
usb_put_dev(usbdev);
return -ENODEV;
}
@@ -719,7 +719,9 @@ static int uss720_probe(struct usb_interface *intf,
priv->pp = pp;
pp->private_data = priv;
- pp->modes = PARPORT_MODE_PCSPP | PARPORT_MODE_TRISTATE | PARPORT_MODE_EPP | PARPORT_MODE_ECP | PARPORT_MODE_COMPAT;
+ pp->modes = PARPORT_MODE_PCSPP | PARPORT_MODE_TRISTATE | PARPORT_MODE_EPP | PARPORT_MODE_COMPAT;
+ if (interface->desc.bNumEndpoints >= 3)
+ pp->modes |= PARPORT_MODE_ECP;
pp->dev = &usbdev->dev;
/* set the USS720 control register to manual mode, no ECP compression, enable all ints */
@@ -774,6 +776,7 @@ static const struct usb_device_id uss720_table[] = {
{ USB_DEVICE(0x050d, 0x1202) }, /* Belkin F5U120-PC */
{ USB_DEVICE(0x0557, 0x2001) },
{ USB_DEVICE(0x05ab, 0x0002) }, /* Belkin F5U002 ISD-101 */
+ { USB_DEVICE(0x05ab, 0x1001) }, /* Belkin F5U002 P80453-A */
{ USB_DEVICE(0x06c6, 0x0100) }, /* Infowave ISD-103 */
{ USB_DEVICE(0x0729, 0x1284) },
{ USB_DEVICE(0x1293, 0x0002) },
--
2.44.0
