eee_active is set by phy_ethtool_get_eee() already, using the same
logic plus an additional check against link speed/duplex values.
See genphy_c45_eee_is_active() for details.
So we can remove this line.
Signed-off-by: Heiner Kallweit <hkallweit1@xxxxxxxxx>
---
drivers/net/usb/lan78xx.c | 2 --
1 file changed, 2 deletions(-)
diff --git a/drivers/net/usb/lan78xx.c b/drivers/net/usb/lan78xx.c
index 5add4145d..a6d653ff5 100644
--- a/drivers/net/usb/lan78xx.c
+++ b/drivers/net/usb/lan78xx.c
@@ -1691,8 +1691,6 @@ static int lan78xx_get_eee(struct net_device *net, struct ethtool_eee *edata)
ret = lan78xx_read_reg(dev, MAC_CR, &buf);
if (buf & MAC_CR_EEE_EN_) {
edata->eee_enabled = true;
- edata->eee_active = !!(edata->advertised &
- edata->lp_advertised);
edata->tx_lpi_enabled = true;
/* EEE_TX_LPI_REQ_DLY & tx_lpi_timer are same uSec unit */
ret = lan78xx_read_reg(dev, EEE_TX_LPI_REQ_DLY, &buf);
--
2.43.0
