Hi Fabio,
>
> On Mon, Dec 18, 2023 at 5:49 AM Xu Yang <xu.yang_2@xxxxxxx> wrote:
>
> > +
> > + ptn5150_1: typec@1d {
> > + compatible = "nxp,ptn5150";
> > + reg = <0x1d>;
> > + int-gpios = <&gpiof 3 IRQ_TYPE_EDGE_FALLING>;
> > + pinctrl-names = "default";
> > + pinctrl-0 = <&pinctrl_typec1>;
> > + status = "disabled";
>
> Why disabled?
As we talked before, I just present these nodes here since the
i.MX8ULP board does have these chips. And I think the above
information is enough to let people know and use it if they
really want. In most of the cases, it's not needed.
>
> No connector and no port properties. Please run dt-schema check
> against linux-next.
The ptn5150 driver doesn't have any relation with typec subsystem. As
Jun said, it uses extcon.
Also I have run dt-schema check, no warnings.
Thanks,
Xu Yang
>
> > + };
> > +
> > + ptn5150_2: typec@3d {
> > + compatible = "nxp,ptn5150";
> > + reg = <0x3d>;
> > + int-gpios = <&gpiof 5 IRQ_TYPE_EDGE_FALLING>;
> > + pinctrl-names = "default";
> > + pinctrl-0 = <&pinctrl_typec2>;
> > + status = "disabled";
>
> Same here.
