From: Gil Fine <gil.fine@xxxxxxxxxxxxxxx> Fix the lane bonding procedure to follow the steps described in USB4 Connection Manager guide. Hence, set the lane bonding bit only for downstream port. This is needed for certain ASMedia device, otherwise lane bonding fails and the device disconnects. Cc: stable@xxxxxxxxxxxxxxx Signed-off-by: Gil Fine <gil.fine@xxxxxxxxxxxxxxx> Signed-off-by: Mika Westerberg <mika.westerberg@xxxxxxxxxxxxxxx> --- drivers/thunderbolt/switch.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/drivers/thunderbolt/switch.c b/drivers/thunderbolt/switch.c index 1e15ffa79295..9e5cc285cc8d 100644 --- a/drivers/thunderbolt/switch.c +++ b/drivers/thunderbolt/switch.c @@ -1143,7 +1143,7 @@ int tb_port_lane_bonding_enable(struct tb_port *port) * Only set bonding if the link was not already bonded. This * avoids the lane adapter to re-enter bonding state. */ - if (width == TB_LINK_WIDTH_SINGLE) { + if (width == TB_LINK_WIDTH_SINGLE && !tb_is_upstream_port(port)) { ret = tb_port_set_lane_bonding(port, true); if (ret) goto err_lane1; -- 2.42.0