hi Pawel Laszczak Recently, I met the problem when use uvc. UVC report jpg header error. Basic reproduce steps. Gadget side: 1 - https://gist.github.com/kbingham/c39c4cc7c20882a104c08df5206e2f9f?permalink_comment_id=3270713 uvc-gadget.sh start 2 - https://git.ideasonboard.org/uvc-gadget.git uvc-gadget -i test.jpg Host side: https://github.com/thekvs/uvccapture2 uvccapture2 --device /dev/video0 --resolution 640x360 --count 1 --result 8qxp.jpeg It will report jpeg header error. After debugs, I found two problem. Problem 1, sg is enabled. so uvc driver will use sg. each package include two trb, trb0 is 8bytes header, trb1 is 1016bytes. total 1024. num_trb here is wrong. it should be num_trb = priv_ep->interval * request->num_mapped_sgs. because priv_ep->interval is 1, I just simple set to request->num_mapped_sg as below patch. USB analyer show one whole 1024 ISO package sent out as expectation although document said only support one TD when use ISO (Maybe my doc is too old). diff --git a/drivers/usb/cdns3/cdns3-gadget.c b/drivers/usb/cdns3/cdns3-gadget.c index 69a44bd7e5d02..8cc99a885883f 100644 --- a/drivers/usb/cdns3/cdns3-gadget.c +++ b/drivers/usb/cdns3/cdns3-gadget.c @@ -1125,10 +1125,7 @@ static int cdns3_ep_run_transfer(struct cdns3_endpoint *priv_ep, struct scatterlist *s = NULL; bool sg_supported = !!(request->num_mapped_sgs); - if (priv_ep->type == USB_ENDPOINT_XFER_ISOC) - num_trb = priv_ep->interval; - else - num_trb = sg_supported ? request->num_mapped_sgs : 1; + num_trb = sg_supported ? request->num_mapped_sgs : 1; if (num_trb > priv_ep->free_trbs) { priv_ep->flags |= EP_RING_FULL; *** Problem 2 *** According to doc and my observation, looks like hardware fetch data into FIFO when get SOF, then transfer data when get IN token. Each SOF will increase TRB regardless it is ready or not. When gadget complete equeue ISO data, so SOF will increase TRB regardless if there are IN token. SOF SOF SOF SOF IN SOF .... TRB0 TRB1 TRB2 TRB3 ... Host may start get data at some time after gadget queue data. So TRB0..2 data will be lost. If it is audio data, it should be okay. But for uvc, it is jpeg header, so host side report error. I checked dwc gadget driver, which start equeue ISO data only get NYET. I check cdns spec, there are ISOERR. But it is never happen. According to document, ISOERR should issue when IN token and FIFO no data. I tried below method 1. Delay queue TRB, but no ISOERR. 2. queue a lenght 0 TRB,but no ISOERR My question is how to delay queue TRB to ISO IN token really happen to avoid lost JPEG header. Frank
