On 10/2/2023 22:51, Benoît Monin wrote:
Following a firmware update of the modem, the interface for the AT
command port changed, so add it back.
T: Bus=08 Lev=01 Prnt=01 Port=01 Cnt=02 Dev#= 2 Spd=5000 MxCh= 0
D: Ver= 3.20 Cls=00(>ifc ) Sub=00 Prot=00 MxPS= 9 #Cfgs= 1
P: Vendor=1199 ProdID=90d3 Rev=00.06
S: Manufacturer=Sierra Wireless, Incorporated
S: Product=Sierra Wireless EM9191
S: SerialNumber=xxxxxxxxxxxxxxxx
C: #Ifs= 4 Cfg#= 1 Atr=a0 MxPwr=896mA
I: If#=0x0 Alt= 0 #EPs= 1 Cls=02(commc) Sub=0e Prot=00 Driver=cdc_mbim
I: If#=0x1 Alt= 1 #EPs= 2 Cls=0a(data ) Sub=00 Prot=02 Driver=cdc_mbim
I: If#=0x3 Alt= 0 #EPs= 3 Cls=ff(vend.) Sub=ff Prot=40 Driver=(none)
I: If#=0x4 Alt= 0 #EPs= 2 Cls=ff(vend.) Sub=ff Prot=30 Driver=option
Signed-off-by: Benoît Monin <benoit.monin@xxxxxx>
---
drivers/usb/serial/option.c | 1 +
1 file changed, 1 insertion(+)
diff --git a/drivers/usb/serial/option.c b/drivers/usb/serial/option.c
index 7994a4549a6c..73971a3a1897 100644
--- a/drivers/usb/serial/option.c
+++ b/drivers/usb/serial/option.c
@@ -2262,6 +2262,7 @@ static const struct usb_device_id option_ids[] = {
{ USB_DEVICE_INTERFACE_CLASS(0x305a, 0x1406, 0xff) }, /* GosunCn GM500 ECM/NCM */
{ USB_DEVICE_AND_INTERFACE_INFO(OPPO_VENDOR_ID, OPPO_PRODUCT_R11, 0xff, 0xff, 0x30) },
{ USB_DEVICE_AND_INTERFACE_INFO(SIERRA_VENDOR_ID, SIERRA_PRODUCT_EM9191, 0xff, 0xff, 0x30) },
+ { USB_DEVICE_AND_INTERFACE_INFO(SIERRA_VENDOR_ID, SIERRA_PRODUCT_EM9191, 0xff, 0xff, 0x40) },
{ USB_DEVICE_AND_INTERFACE_INFO(SIERRA_VENDOR_ID, SIERRA_PRODUCT_EM9191, 0xff, 0, 0) },
{ USB_DEVICE_AND_INTERFACE_INFO(UNISOC_VENDOR_ID, TOZED_PRODUCT_LT70C, 0xff, 0, 0) },
{ } /* Terminating entry */
No need to add additional lines in the driver, the entry can be
simplified by removing the previous two lines and add a single line
using the USB_DEVICE_INTERFACE_CLASS macro.
Thanks
Lars
