From: Abdel Alkuor <abdelalkuor@xxxxxxxxxx> When an EEPROM is present, tps25750 loads the binary configuration from EEPROM. Hence, all we need to do is wait for the device to switch to APP mode Signed-off-by: Abdel Alkuor <abdelalkuor@xxxxxxxxxx> --- Changes in v6: - Update eeprom macro to use TPS instead Changes in v5: - Incorporating tps25750 into tps6598x driver drivers/usb/typec/tipd/core.c | 13 +++++++++++++ drivers/usb/typec/tipd/tps6598x.h | 3 +++ 2 files changed, 16 insertions(+) diff --git a/drivers/usb/typec/tipd/core.c b/drivers/usb/typec/tipd/core.c index d2f82f191e4a..7c08669400a8 100644 --- a/drivers/usb/typec/tipd/core.c +++ b/drivers/usb/typec/tipd/core.c @@ -37,6 +37,7 @@ #define TPS_REG_STATUS 0x1a #define TPS_REG_SYSTEM_CONF 0x28 #define TPS_REG_CTRL_CONF 0x29 +#define TPS_REG_BOOT_STATUS 0x2D #define TPS_REG_POWER_STATUS 0x3f #define TPS_REG_RX_IDENTITY_SOP 0x48 #define TPS_REG_DATA_STATUS 0x5f @@ -898,6 +899,17 @@ static int tps25750_apply_patch(struct tps6598x *tps) { int ret; unsigned long timeout; + u64 status = 0; + + ret = tps6598x_block_read(tps, TPS_REG_BOOT_STATUS, &status, 5); + if (ret) + return ret; + /* + * Nothing to be done if the configuration + * is being loaded from EERPOM + */ + if (status & TPS_BOOT_STATUS_I2C_EEPROM_PRESENT) + goto wait_for_app; ret = tps25750_start_patch_burst_mode(tps); if (ret) { @@ -909,6 +921,7 @@ static int tps25750_apply_patch(struct tps6598x *tps) if (ret) return ret; +wait_for_app: timeout = jiffies + msecs_to_jiffies(1000); do { diff --git a/drivers/usb/typec/tipd/tps6598x.h b/drivers/usb/typec/tipd/tps6598x.h index 527857549d69..a80d0929f3ee 100644 --- a/drivers/usb/typec/tipd/tps6598x.h +++ b/drivers/usb/typec/tipd/tps6598x.h @@ -199,4 +199,7 @@ #define TPS_DATA_STATUS_DP_SPEC_PIN_ASSIGNMENT_A BIT(2) #define TPS_DATA_STATUS_DP_SPEC_PIN_ASSIGNMENT_B (BIT(2) | BIT(1)) +/* BOOT STATUS REG*/ +#define TPS_BOOT_STATUS_I2C_EEPROM_PRESENT BIT(3) + #endif /* __TPS6598X_H__ */ -- 2.34.1