[PATCH v10 11/11] arm64: dts: qcom: sa8540-ride: Enable first port of tertiary usb controller

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



From: Andrew Halaney <ahalaney@xxxxxxxxxx>

There is now support for the multiport USB controller this uses so
enable it.

The board only has a single port hooked up (despite it being wired up to
the multiport IP on the SoC). There's also a USB 2.0 mux hooked up,
which by default on boot is selected to mux properly. Grab the gpio
controlling that and ensure it stays in the right position so USB 2.0
continues to be routed from the external port to the SoC.

Co-developed-by: Andrew Halaney <ahalaney@xxxxxxxxxx>
Signed-off-by: Andrew Halaney <ahalaney@xxxxxxxxxx>
[Krishna: Rebased on top of usb-next]
Co-developed-by: Krishna Kurapati <quic_kriskura@xxxxxxxxxxx>
Signed-off-by: Krishna Kurapati <quic_kriskura@xxxxxxxxxxx>
---
 arch/arm64/boot/dts/qcom/sa8540p-ride.dts | 22 ++++++++++++++++++++++
 1 file changed, 22 insertions(+)

diff --git a/arch/arm64/boot/dts/qcom/sa8540p-ride.dts b/arch/arm64/boot/dts/qcom/sa8540p-ride.dts
index 5a26974dcf8f..69f6b13e6197 100644
--- a/arch/arm64/boot/dts/qcom/sa8540p-ride.dts
+++ b/arch/arm64/boot/dts/qcom/sa8540p-ride.dts
@@ -488,6 +488,19 @@ &usb_2_qmpphy0 {
 	status = "okay";
 };
 
+&usb_2 {
+	pinctrl-0 = <&usb2_en_state>;
+	pinctrl-names = "default";
+
+	status = "okay";
+};
+
+&usb_2_dwc3 {
+	dr_mode = "host";
+	phy-names = "usb2-port0", "usb3-port0";
+	phys = <&usb_2_hsphy0>, <&usb_2_qmpphy0>;
+};
+
 &xo_board_clk {
 	clock-frequency = <38400000>;
 };
@@ -640,4 +653,13 @@ wake-pins {
 			bias-pull-up;
 		};
 	};
+
+	usb2_en_state: usb2-en-state {
+		/* TS3USB221A USB2.0 mux select */
+		pins = "gpio24";
+		function = "gpio";
+		drive-strength = <2>;
+		bias-disable;
+		output-low;
+	};
 };
-- 
2.40.0




[Index of Archives]     [Linux Media]     [Linux Input]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [Old Linux USB Devel Archive]

  Powered by Linux