On Sun, Jun 18, 2023 at 05:39:49PM +0530, Krishna Kurapati wrote:
> In scenarios where pullup relies on resume (get sync) to initialize
> the controller and set the run stop bit, then core_init is followed by
> gadget_resume which will eventually set run stop bit.
>
> But in cases where the core_init fails, the return value is not sent
> back to udc appropriately. So according to UDC the controller has
> started but in reality we never set the run stop bit.
>
> On systems like Android, there are uevents sent to HAL depending on
> whether the configfs_bind / configfs_disconnect were invoked. In the
> above mentioned scnenario, if the core init fails, the run stop won't
> be set and the cable plug-out won't result in generation of any
> disconnect event and userspace would never get any uevent regarding
> cable plug out and we never call pullup(0) again. Furthermore none of
> the next Plug-In/Plug-Out's would be known to configfs.
>
> Return back the appropriate result to UDC to let the userspace/
> configfs know that the pullup failed so they can take appropriate
> action.
>
> Fixes: 77adb8bdf422 ("usb: dwc3: gadget: Allow runtime suspend if UDC unbinded")
> Signed-off-by: Krishna Kurapati <quic_kriskura@xxxxxxxxxxx>
> Acked-by: Thinh Nguyen <Thinh.Nguyen@xxxxxxxxxxxx>
> ---
> Changes in v3: Added changelog mising in v2
> Changes in v2: Added Fixes tag
>
> drivers/usb/dwc3/gadget.c | 4 +++-
> 1 file changed, 3 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/usb/dwc3/gadget.c b/drivers/usb/dwc3/gadget.c
> index 578804dc29ca..27cb671e18e3 100644
> --- a/drivers/usb/dwc3/gadget.c
> +++ b/drivers/usb/dwc3/gadget.c
> @@ -2747,7 +2747,9 @@ static int dwc3_gadget_pullup(struct usb_gadget *g, int is_on)
> ret = pm_runtime_get_sync(dwc->dev);
> if (!ret || ret < 0) {
> pm_runtime_put(dwc->dev);
> - return 0;
> + if (ret < 0)
> + pm_runtime_set_suspended(dwc->dev);
This bit is broken and is also not mentioned or explained in the commit
message. What are you trying to achieve here?
You cannot set the state like this after runtime PM is enabled and the
above call will always fail.
> + return ret;
> }
>
> if (dwc->pullups_connected == is_on) {
Johan
