On Thu, May 25, 2023 at 05:38:18PM +0000, Roy Luo wrote:
> Expose usb device state to userland as the information is useful in
> detecting non-compliant setups and diagnosing enumeration failures.
> For example:
> - End-to-end signal integrity issues: the device would fail port reset
> repeatedly and thus be stuck in POWERED state.
> - Charge-only cables (missing D+/D- lines): the device would never enter
> POWERED state as the HC would not see any pullup.
>
> What's the status quo?
> We do have error logs such as "Cannot enable. Maybe the USB cable is bad?"
> to flag potential setup issues, but there's no good way to expose them to
> userspace.
>
> Why add a sysfs entry in struct usb_port instead of struct usb_device?
> The struct usb_device is not device_add() to the system until it's in
> ADDRESS state hence we would miss the first two states. The struct
> usb_port is a better place to keep the information because its life
> cycle is longer than the struct usb_device that is attached to the port.
>
> Signed-off-by: Roy Luo <royluo@xxxxxxxxxx>
> ---
> diff --git a/drivers/usb/core/hub.h b/drivers/usb/core/hub.h
> index e23833562e4f..110143568c77 100644
> --- a/drivers/usb/core/hub.h
> +++ b/drivers/usb/core/hub.h
> @@ -84,8 +84,10 @@ struct usb_hub {
> * @peer: related usb2 and usb3 ports (share the same connector)
> * @req: default pm qos request for hubs without port power control
> * @connect_type: port's connect type
> + * @state: device state of the usb device attached to the port
This member is essentially a duplicate of the .child member of the
usb_port structure. That is, it points to the .state member of the
child device instead of to the child device itself, but this is pretty
much the same thing. You could replace *(port_dev->state) with
port_dev->child->state.
> diff --git a/drivers/usb/core/port.c b/drivers/usb/core/port.c
> index 06a8f1f84f6f..7f3430170115 100644
> --- a/drivers/usb/core/port.c
> +++ b/drivers/usb/core/port.c
> @@ -160,6 +160,19 @@ static ssize_t connect_type_show(struct device *dev,
> }
> static DEVICE_ATTR_RO(connect_type);
>
> +static ssize_t state_show(struct device *dev,
> + struct device_attribute *attr, char *buf)
> +{
> + struct usb_port *port_dev = to_usb_port(dev);
> + enum usb_device_state state = USB_STATE_NOTATTACHED;
> +
> + if (port_dev->state)
> + state = *port_dev->state;
> +
> + return sprintf(buf, "%s\n", usb_state_string(state));
This races with device addition and removal (and with device state
changes). To prevent these races, you have to hold the
device_state_lock spinlock while accessing the child device and its
state.
Unfortunately that spinlock is private to hub.c, so you will have to
make it public before you can use it here.
Alan Stern
