On Mon, Dec 19, 2022 at 01:47:59PM +0100, Flavio Suligoi wrote:
> The Texas Instruments TUSB8041 has an autosuspend problem at high
> temperature.
>
> If there is not USB traffic, after a couple of ms, the device enters in
> autosuspend mode. In this condition the external clock stops working, to
> save energy. When the USB activity turns on, ther hub exits the
> autosuspend state, the clock starts running again and all works fine.
>
> At ambient temperature all works correctly, but at high temperature,
> when the USB activity turns on, the external clock doesn't restart and
> the hub disappears from the USB bus.
>
> Disabling the autosuspend mode for this hub solves the issue.
>
> Signed-off-by: Flavio Suligoi <f.suligoi@xxxxxxx>
> ---
Acked-by: Alan Stern <stern@xxxxxxxxxxxxxxxxxxx>
> v2: set TUSB8041 vendor id directly as hexnumber, instead of a complex formula
>
> drivers/usb/core/hub.c | 13 +++++++++++++
> 1 file changed, 13 insertions(+)
>
> diff --git a/drivers/usb/core/hub.c b/drivers/usb/core/hub.c
> index 77e73fc8d673..9eca403af2a8 100644
> --- a/drivers/usb/core/hub.c
> +++ b/drivers/usb/core/hub.c
> @@ -44,6 +44,9 @@
> #define USB_PRODUCT_USB5534B 0x5534
> #define USB_VENDOR_CYPRESS 0x04b4
> #define USB_PRODUCT_CY7C65632 0x6570
> +#define USB_VENDOR_TEXAS_INSTRUMENTS 0x0451
> +#define USB_PRODUCT_TUSB8041_USB3 0x8140
> +#define USB_PRODUCT_TUSB8041_USB2 0x8142
> #define HUB_QUIRK_CHECK_PORT_AUTOSUSPEND 0x01
> #define HUB_QUIRK_DISABLE_AUTOSUSPEND 0x02
>
> @@ -5854,6 +5857,16 @@ static const struct usb_device_id hub_id_table[] = {
> .idVendor = USB_VENDOR_GENESYS_LOGIC,
> .bInterfaceClass = USB_CLASS_HUB,
> .driver_info = HUB_QUIRK_CHECK_PORT_AUTOSUSPEND},
> + { .match_flags = USB_DEVICE_ID_MATCH_VENDOR
> + | USB_DEVICE_ID_MATCH_PRODUCT,
> + .idVendor = USB_VENDOR_TEXAS_INSTRUMENTS,
> + .idProduct = USB_PRODUCT_TUSB8041_USB2,
> + .driver_info = HUB_QUIRK_DISABLE_AUTOSUSPEND},
> + { .match_flags = USB_DEVICE_ID_MATCH_VENDOR
> + | USB_DEVICE_ID_MATCH_PRODUCT,
> + .idVendor = USB_VENDOR_TEXAS_INSTRUMENTS,
> + .idProduct = USB_PRODUCT_TUSB8041_USB3,
> + .driver_info = HUB_QUIRK_DISABLE_AUTOSUSPEND},
> { .match_flags = USB_DEVICE_ID_MATCH_DEV_CLASS,
> .bDeviceClass = USB_CLASS_HUB},
> { .match_flags = USB_DEVICE_ID_MATCH_INT_CLASS,
> --
> 2.25.1
>
