Changes in v4: - Split the increase timeout patch into separate patches. #1 for the gadget suspend/resume locking changes #2 for the increased timeout - Modified msleep to usleep_range w/ an interval of 1-2ms and a max timeout of 4s. Changes in v3: - Modified the msleep() duration to ~2s versus ~10s due to the minimum mdelay() value. - Removed patch to modify DEP flags during dwc3_stop_active_transfer(). This was not required after fixing the logic to allow EP xfercomplete events to be handled on EP0. - Added some changes to account for a cable disconnect scenario, where dwc3_gadget_pullup() would not be executed to stop active transfers. Needed to add some logic to the disconnect interrupt to ensure that we cleanup/restart any pending SETUP transaction, so that we can clear the EP0 delayed stop status. (if pending) - Added patch to ensure that we don't proceed with umapping buffers until the endxfer was actually sent. Changes in v2: - Moved msleep() to before reading status register for halted state - Fixed kernel bot errors - Clearing DEP flags in __dwc3_stop_active_transfers() - Added Suggested-by tags and link references to previous discussions This patch series addresses some issues seen while testing with the latest soft disconnect implementation where EP events are allowed to process while the controller halt is occurring. #1 Since routines can now interweave, we can see that the soft disconnect can occur while conndone is being serviced. This leads to a controller halt timeout, as the soft disconnect clears the DEP flags, for which conndone interrupt handler will issue a __dwc3_ep_enable(ep0), that leads to re-issuing the set ep config command for every endpoint. #2 Function drivers can ask for a delayed_status phase, while it processes the received SETUP packet. This can lead to large delays when handling the soft disconnect routine. To improve the timing, forcefully send the status phase, as we are going to disconnect from the host. #3 Ensure that local interrupts are left enabled, so that EP0 events can be processed while the soft disconnect/dequeue is happening. #4 Since EP0 events can occur during controller halt, it may increase the time needed for the controller to fully stop. #5 Account for cable disconnect scenarios where nothing may cause the endxfer retry if DWC3_EP_DELAY_STOP is set. #6 Avoid unmapping pending USB requests that were never stopped. This would lead to a potential SMMU fault. Wesley Cheng (9): usb: dwc3: Do not service EP0 and conndone events if soft disconnected usb: dwc3: gadget: Force sending delayed status during soft disconnect usb: dwc3: gadget: Synchronize IRQ between soft connect/disconnect usb: dwc3: gadget: Continue handling EP0 xfercomplete events usb: dwc3: Avoid unmapping USB requests if endxfer is not complete usb: dwc3: Remove DWC3 locking during gadget suspend/resume usb: dwc3: Increase DWC3 controller halt timeout usb: dwc3: gadget: Skip waiting for CMDACT cleared during endxfer usb: dwc3: gadget: Submit endxfer command if delayed during disconnect drivers/usb/dwc3/core.c | 4 ---- drivers/usb/dwc3/core.h | 3 +++ drivers/usb/dwc3/ep0.c | 11 ++++++--- drivers/usb/dwc3/gadget.c | 48 +++++++++++++++++++++++++++++++++------ 4 files changed, 52 insertions(+), 14 deletions(-)
