Relocate the pullups_connected check until after it is ensured that there
are no runtime PM transitions. If another context triggered the DWC3
core's runtime resume, it may have already enabled the Run/Stop. Do not
re-run the entire pullup sequence again, as it may issue a core soft
reset while Run/Stop is already set.
Signed-off-by: Wesley Cheng <quic_wcheng@xxxxxxxxxxx>
---
drivers/usb/dwc3/gadget.c | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/drivers/usb/dwc3/gadget.c b/drivers/usb/dwc3/gadget.c
index aeeec751c53c..67b1039c664c 100644
--- a/drivers/usb/dwc3/gadget.c
+++ b/drivers/usb/dwc3/gadget.c
@@ -2539,9 +2539,6 @@ static int dwc3_gadget_pullup(struct usb_gadget *g, int is_on)
is_on = !!is_on;
- if (dwc->pullups_connected == is_on)
- return 0;
-
dwc->softconnect = is_on;
/*
@@ -2566,6 +2563,9 @@ static int dwc3_gadget_pullup(struct usb_gadget *g, int is_on)
return 0;
}
+ if (dwc->pullups_connected == is_on)
+ return 0;
+
if (!is_on) {
ret = dwc3_gadget_soft_disconnect(dwc);
} else {
