Hi all, I just resent the full series as I got some issues with my mailer. Sorry for the noise, please drop this one. Best Regards, Fabrice On 7/11/22 13:48, Fabrice Gasnier wrote: > STM32G0 provides an integrated USB Type-C and power delivery interface [1]. > It can be programmed with a firmware [2] to act as a PPM. Currently it > implements UCSI protocol over I2C interface. A GPIO is used as an interrupt > line. > > This series adds a driver to support it, including: > - dt-bindings documentation > - optional STM32G0 firmware control and update, over a secondary I2C address > - power management > > [1] https://wiki.st.com/stm32mcu/wiki/Introduction_to_USB_Power_Delivery_with_STM32 > [2] https://github.com/STMicroelectronics/x-cube-ucsi > > Changes in v2: > - Krzysztof's review comments on dt-bindings: update commit message, use ports, > use unevaluatedProperties: false for usb-connector schema, define maxItems > for power-domains, adopt generic node names, remove quotes. > - Christophe's comments on driver: > use kmalloc instead of kzalloc > Use-after-free of buf: directly print the offset > > Fabrice Gasnier (4): > dt-bindings: usb: typec: add bindings for stm32g0 controller > usb: typec: ucsi: stm32g0: add support for stm32g0 i2c controller > usb: typec: ucsi: stm32g0: add bootloader support > usb: typec: ucsi: stm32g0: add support for power management > > .../bindings/usb/st,typec-stm32g0.yaml | 90 ++ > drivers/usb/typec/ucsi/Kconfig | 10 + > drivers/usb/typec/ucsi/Makefile | 1 + > drivers/usb/typec/ucsi/ucsi_stm32g0.c | 777 ++++++++++++++++++ > 4 files changed, 878 insertions(+) > create mode 100644 Documentation/devicetree/bindings/usb/st,typec-stm32g0.yaml > create mode 100644 drivers/usb/typec/ucsi/ucsi_stm32g0.c >
