The support the external role switch a variety of situations were addressed, but the transition from USB_ROLE_HOST to USB_ROLE_NONE leaves the host up which can cause some error messages when switching from host to none, to gadget, to none, and then back to host again. xhci-hcd ee000000.usb: Abort failed to stop command ring: -110 xhci-hcd ee000000.usb: xHCI host controller not responding, assume dead xhci-hcd ee000000.usb: HC died; cleaning up usb 4-1: device not accepting address 6, error -108 usb usb4-port1: couldn't allocate usb_device After this happens it will not act as a host again. Fix this by releasing the host mode when transitioning to USB_ROLE_NONE. Fixes: 0604160d8c0b ("usb: gadget: udc: renesas_usb3: Enhance role switch support") Signed-off-by: Adam Ford <aford173@xxxxxxxxx> diff --git a/drivers/usb/gadget/udc/renesas_usb3.c b/drivers/usb/gadget/udc/renesas_usb3.c index 57d417a7c3e0..601829a6b4ba 100644 --- a/drivers/usb/gadget/udc/renesas_usb3.c +++ b/drivers/usb/gadget/udc/renesas_usb3.c @@ -2378,6 +2378,8 @@ static void handle_ext_role_switch_states(struct device *dev, switch (role) { case USB_ROLE_NONE: usb3->connection_state = USB_ROLE_NONE; + if (cur_role == USB_ROLE_HOST) + device_release_driver(host); if (usb3->driver) usb3_disconnect(usb3); usb3_vbus_out(usb3, false); -- 2.32.0