When activate_stm_id_vb_detection is enabled, ID and Vbus detection relies
on sensing comparators. This detection needs time to stabilize.
A delay was already applied in dwc2_resume() when reactivating the
detection, but it wasn't done in dwc2_probe().
This patch adds delay after enabling STM ID/VBUS detection. Then, ID state
is good when initializing gadget and host, and avoid to get a wrong
Connector ID Status Change interrupt.
Fixes: a415083a11cc ("usb: dwc2: add support for STM32MP15 SoCs USB OTG HS and FS")
Signed-off-by: Amelie Delaunay <amelie.delaunay@xxxxxxxxxxx>
---
drivers/usb/dwc2/platform.c | 3 +++
1 file changed, 3 insertions(+)
diff --git a/drivers/usb/dwc2/platform.c b/drivers/usb/dwc2/platform.c
index a1feaa09be57..55d7fca6f95c 100644
--- a/drivers/usb/dwc2/platform.c
+++ b/drivers/usb/dwc2/platform.c
@@ -555,6 +555,9 @@ static int dwc2_driver_probe(struct platform_device *dev)
ggpio |= GGPIO_STM32_OTG_GCCFG_IDEN;
ggpio |= GGPIO_STM32_OTG_GCCFG_VBDEN;
dwc2_writel(hsotg, ggpio, GGPIO);
+
+ /* ID/VBUS detection startup time */
+ usleep_range(5000, 7000);
}
retval = dwc2_drd_init(hsotg);
--
2.25.1
