Re: [PATCH] usb: hub: Fix usb enumeration issue due to address0 race

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 18.11.2021 13.19, Marek Szyprowski wrote:
> Hi,
> 
> On 15.11.2021 23:16, Mathias Nyman wrote:
>> xHC hardware can only have one slot in default state with address 0
>> waiting for a unique address at a time, otherwise "undefined behavior
>> may occur" according to xhci spec 5.4.3.4
>>
>> The address0_mutex exists to prevent this across both xhci roothubs.
>>
>> If hub_port_init() fails, it may unlock the mutex and exit with a xhci
>> slot in default state. If the other xhci roothub calls hub_port_init()
>> at this point we end up with two slots in default state.
>>
>> Make sure the address0_mutex protects the slot default state across
>> hub_port_init() retries, until slot is addressed or disabled.
>>
>> Note, one known minor case is not fixed by this patch.
>> If device needs to be reset during resume, but fails all hub_port_init()
>> retries in usb_reset_and_verify_device(), then it's possible the slot is
>> still left in default state when address0_mutex is unlocked.
>>
>> Cc: <stable@xxxxxxxxxxxxxxx>
>> Signed-off-by: Mathias Nyman <mathias.nyman@xxxxxxxxxxxxxxx>
> 
> This patch landed in linux next-20211118 as commit 6ae6dc22d2d1 ("usb: 
> hub: Fix usb enumeration issue due to address0 race"). On my test 
> systems it triggers the following deplock warning during system 
> suspend/resume cycle:
> 
> ======================================================
> WARNING: possible circular locking dependency detected
> 5.16.0-rc1-00014-g6ae6dc22d2d1 #4126 Not tainted
> ------------------------------------------------------
> kworker/u16:8/738 is trying to acquire lock:
> cf81f738 (hcd->address0_mutex){+.+.}-{3:3}, at: 
> usb_reset_and_verify_device+0xe8/0x3e4
> 
> but task is already holding lock:
> cf80ab3c (&port_dev->status_lock){+.+.}-{3:3}, at: 
> usb_port_resume+0xa0/0x7e8
> 

Thanks, I see it now.

Lock order is:
  mutex_lock(&port_dev->status_lock)
    mutex_lock(hcd->address0_mutex)
    mutex_unlock(hcd->address0_mutex)
  mutex_unlock(&port_dev->status_lock)
in hub_port_connect(), usb_port_resume() and usb_reset_device()

But patch changed the status_lock and address0_mutex lock order in hub_port_connect().
Lets see if we can take the status_lock a bit earlier in hub_port_connect() to
solve this.

-Mathias



[Index of Archives]     [Linux Media]     [Linux Input]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [Old Linux USB Devel Archive]

  Powered by Linux