On Wed, Oct 13, 2021 at 06:53:46PM +0200, Fabrice Gasnier wrote: > Document the "port" property, which is used with "usb-role-switch" > to describe the bus connector. > Definition is inspired from mediatek,mtu3.yaml. > > This fixes some errors seen when running "make dtbs_check": > ... 'port' does not match any of the regexes: 'pinctrl-[0-9]+' > From schema: ... Documentation/devicetree/bindings/usb/dwc2.yaml > > Signed-off-by: Fabrice Gasnier <fabrice.gasnier@xxxxxxxxxxx> > --- > Documentation/devicetree/bindings/usb/dwc2.yaml | 10 ++++++++++ > 1 file changed, 10 insertions(+) > > diff --git a/Documentation/devicetree/bindings/usb/dwc2.yaml b/Documentation/devicetree/bindings/usb/dwc2.yaml > index 10c7d9b..7d1aa53 100644 > --- a/Documentation/devicetree/bindings/usb/dwc2.yaml > +++ b/Documentation/devicetree/bindings/usb/dwc2.yaml > @@ -130,6 +130,16 @@ properties: > description: If present indicates that we need to reset the PHY when we > detect a wakeup. This is due to a hardware errata. > > + port: > + description: > + Any connector to the data bus of this controller should be modelled > + using the OF graph bindings specified, if the "usb-role-switch" > + property is used. See graph.txt Drop 'See graph.txt' > + $ref: /schemas/graph.yaml#/properties/port > + > +dependencies: > + port: [ 'usb-role-switch' ] usb-role-switch without port is valid or both must be present. In case of the latter, you need to add: usb-role-switch: [ port ] Also, you don't need quotes. > + > required: > - compatible > - reg > -- > 2.7.4 > >