Set "HCD_FLAG_DEFER_PRI_RH_REGISTER" to hcd->flags in xhci_run() to defer registering primary roothub in usb_add_hcd(). This will make sure both primary roothub and secondary roothub will be registered along with the second HCD. This is required for cold plugged USB devices to be detected in certain PCIe USB cards (like Inateck USB card connected to AM64 EVM or J7200 EVM). Signed-off-by: Kishon Vijay Abraham I <kishon@xxxxxx> Suggested-by: Mathias Nyman <mathias.nyman@xxxxxxxxxxxxxxx> --- drivers/usb/host/xhci.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/drivers/usb/host/xhci.c b/drivers/usb/host/xhci.c index 3618070eba78..9b7d968022c8 100644 --- a/drivers/usb/host/xhci.c +++ b/drivers/usb/host/xhci.c @@ -644,7 +644,6 @@ int xhci_run(struct usb_hcd *hcd) /* Start the xHCI host controller running only after the USB 2.0 roothub * is setup. */ - hcd->uses_new_polling = 1; if (!usb_hcd_is_primary_hcd(hcd)) return xhci_run_finished(xhci); @@ -692,6 +691,7 @@ int xhci_run(struct usb_hcd *hcd) if (ret) xhci_free_command(xhci, command); } + set_bit(HCD_FLAG_DEFER_PRI_RH_REGISTER, &hcd->flags); xhci_dbg_trace(xhci, trace_xhci_dbg_init, "Finished xhci_run for USB2 roothub"); -- 2.17.1