18.08.2021 07:31, Viresh Kumar пишет:
> On 18-08-21, 07:12, Dmitry Osipenko wrote:
>> 18.08.2021 06:55, Viresh Kumar пишет:
>>> On 17-08-21, 18:49, Dmitry Osipenko wrote:
>>>> 17.08.2021 10:55, Viresh Kumar пишет:
>>>> ...
>>>>>> +int dev_pm_opp_sync(struct device *dev)
>>>>>> +{
>>>>>> + struct opp_table *opp_table;
>>>>>> + struct dev_pm_opp *opp;
>>>>>> + int ret = 0;
>>>>>> +
>>>>>> + /* Device may not have OPP table */
>>>>>> + opp_table = _find_opp_table(dev);
>>>>>> + if (IS_ERR(opp_table))
>>>>>> + return 0;
>>>>>> +
>>>>>> + if (!_get_opp_count(opp_table))
>>>>>> + goto put_table;
>>>>>> +
>>>>>> + opp = _find_current_opp(dev, opp_table);
>>>>>> + ret = _set_opp(dev, opp_table, opp, opp->rate);
>>>>>
>>>>> And I am not sure how this will end up working, since new OPP will be
>>>>> equal to old one. Since I see you call this from resume() at many
>>>>> places.
>>>>
>>>> Initially OPP table is "uninitialized" and opp_table->enabled=false,
>>>> hence the first sync always works even if OPP is equal to old one. Once
>>>> OPP has been synced, all further syncs are NO-OPs, hence it doesn't
>>>> matter how many times syncing is called.
>>>>
>>>> https://elixir.bootlin.com/linux/v5.14-rc6/source/drivers/opp/core.c#L1012
>>>
>>> Right, but how will this work from Resume ? Won't that be a no-op ?
>>
>> The first resume initializes the OPP state on sync, all further syncs on
>> resume are no-ops.
>
> But the OPPs should already be initialized as someone must have called
> opp-set-rate earlier ? Why do this from resume and not probe ?
This will set voltage level without having an actively used hardware.
Take a 3d driver for example, if you set the rate on probe and
rpm-resume will never be called, then the voltage will be set high,
while hardware is kept suspended if userspace will never wake it up by
executing a 3d job.
