Here is an xbox controller. (Note this usb is just a mt76 usb->wifi chip slightly modified). Host commands ---------------------- sudo usbipd & sudo modprobe usbip-host sudo usbip bind -b 1-1.4 Client commands ----------------------- sudo modprobe vhci-hcd sudo usbip attach -r 192.168.1.189 -b 1-1.4 Host dmesg ----------------- [ 61.713164] usbcore: registered new device driver usbip-host [ 99.964196] mt76x2u 1-1.4:1.0: mac specific condition occurred [ 100.212477] usbip-host 1-1.4: usbip-host: register new device (bus 1 dev 3) [ 128.195578] usbip-host 1-1.4: stub up Client dmesg -------------------- [ 184.764560] vhci_hcd vhci_hcd.0: pdev(0) rhport(0) sockfd(3) [ 184.764569] vhci_hcd vhci_hcd.0: devid(65539) speed(3) speed_str(high-speed) [ 184.764592] vhci_hcd vhci_hcd.0: Device attached [ 184.999634] usb 5-1: new high-speed USB device number 2 using vhci_hcd [ 185.127653] usb 5-1: SetAddress Request (2) to port 0 [ 185.173988] usb 5-1: New USB device found, idVendor=045e, idProduct=02e6, bcdDevice= 1.00 [ 185.173996] usb 5-1: New USB device strings: Mfr=1, Product=2, SerialNumber=3 [ 185.174000] usb 5-1: Product: XBOX ACC [ 185.174003] usb 5-1: Manufacturer: Microsoft Inc. [ 185.174005] usb 5-1: SerialNumber: 203124 [ 185.357262] cfg80211: Loading compiled-in X.509 certificates for regulatory database [ 185.357936] cfg80211: Loaded X.509 cert 'sforshee: 00b28ddf47aef9cea7' [ 186.387801] usb usb5-port1: Cannot enable. Maybe the USB cable is bad? [ 187.287921] usb usb5-port1: Cannot enable. Maybe the USB cable is bad? [ 188.188011] usb usb5-port1: Cannot enable. Maybe the USB cable is bad? [ 189.088116] usb usb5-port1: Cannot enable. Maybe the USB cable is bad? [ 189.088169] usb 5-1: USB disconnect, device number 2 [ 189.088789] mt76x2u 5-1:1.0: ASIC revision: ffffffff [ 189.089569] usbcore: registered new interface driver mt76x2u [ 189.988201] usb usb5-port1: Cannot enable. Maybe the USB cable is bad? [ 190.888294] usb usb5-port1: Cannot enable. Maybe the USB cable is bad? [ 190.888321] usb usb5-port1: attempt power cycle [ 192.104419] usb usb5-port1: Cannot enable. Maybe the USB cable is bad? [ 193.004503] usb usb5-port1: Cannot enable. Maybe the USB cable is bad? [ 193.004531] usb usb5-port1: unable to enumerate USB device On Sat, 24 Jul 2021 at 02:29, Shuah Khan <skhan@xxxxxxxxxxxxxxxxxxx> wrote: > > On 7/21/21 8:27 PM, Michael wrote: > > You can pass through any bluetooth dongle (or xbox wireless dongle) through usbip and it will cause this issue. > > > > For example, here is one of my customers https://www.virtualhere.com/comment/9432#comment-9432 <https://www.virtualhere.com/comment/9432#comment-9432> with the issue. > > > > The device is in the VDEV_ST_USED state when a reset occurs and so its never re-enabled > > > > Furthermore there is a bug in the line pr_err("vhci_device speed not set\n"); > > (L479) because resetting a full-speed device is not an error. > > > > Can you provide me the full demsg from host and client including the part > where device is attached? I assume usbip tools from Linux sources are used? > > Also send me lsusb output on host and client > > thanks, > -- Shuah
