On 6/27/21 21:16, Alan Stern wrote:
On Sun, Jun 27, 2021 at 09:05:25PM -0400, Matt Corallo wrote:
On 6/27/21 20:58, Alan Stern wrote:
On Sun, Jun 27, 2021 at 08:32:21PM -0400, Matt Corallo wrote:
On an ODROID-C1/C2 device, using the dwc2 driver, only some devices cause USB bus to enumerate devices.
Specifically, both on boot and during normal operation, if some devices are
plugged in, all USB devices are detected, but if those devices are removed,
no detection of any devices occurs.
So if you boot with no devices plugged in, and then you plug in (say) a
flash drive, it doesn't get detected?
There is a separate and long-standing bug on the ODROID-C1 and ODROID-C2
devices where hotplug doesn't work reliably, which is why I mentioned
rebooting. This specific bug all works identically whether booting fresh
with the devices or testing hotplug (which sometimes works with lsusb -vvv).
That doesn't answer my question. If no devices are plugged in (either
at boot or during normal operation), and then you plug in a device like
a flash drive, does it get detected? What you wrote seems to imply that
it does not.
That is correct, nothing gets auto-detected after boot. lsusb -vvv *does* cause devices in the second group below to be
reliably detected, and the first group only if at least one of the devices in the second group are present.
I sadly don't have a lot more to go on, but xdarklight on IRC (I believe ==
Martin, CC'd) confirmed the findings with a grab bag of USB devices he had
sitting around as well, and may be able to provide CONFIG_USB_DWC2_DEBUG
output.
Any further guidance on where to look to debug this issue would be appreciated.
As a sample, some devices which, when plugged in (either alone or together)
do not cause any USB device detection (see attached lsusb -v files):
Samsung T7 USB 3 drive
Samsung-Branded Silicon Motion USB 3 Flash Drive
Some devices which, when plugged in cause all USB devices to be detected:
Mushkin-Branded Kingston USB 3 Flash Drive
Kingston-Branded Kingston USB 2 Flash Drive
USB-3 MicroSD Card reader (lsusb/testing by xdarklight)
SanDisk USB 3 Flash Drive (lsusb/testign by xdkarlight)
This could simply be a question of power. Most of the flash drives and
the card reader probably don't require very much power, whereas some of
them need more. You can this, to some extent, in the MaxPower fields of
the lsusb -v listings.
That seems strange, though, given that the first group of devices appear and
work totally fine, but only when something from the second group of devices
is plugged in. If the second group is not present, then the first group of
devices do not appear at all.
You mean that only devices in the first group are affected by this bug?
Devices in the second group are always detected correctly regardless of
what else is plugged in? (This contradicts what you wrote above.)
Correct. Ignoring hotplug (ie on fresh boot or lsusb -vvv), the devices in the second group work great. The devices in
the first group do too, but only if a device from the second group is present.
Sorry for the confusion,
Matt
