Hi Andy, On Fri, 11 Dec 2020 at 16:15, Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx> wrote: > > On Thu, Dec 10, 2020 at 10:33:18PM +0200, Sam Protsenko wrote: > > If "port" node is missing in PHY controller node, dwc3_get_extcon() > > isn't able to find extcon device. This is perfectly fine in case when > > "usb-role-switch" or OTG is used, but next misleading error message is > > printed in that case, from of_graph_get_remote_node(): > > > > OF: graph: no port node found in /phy@1234abcd > > > > Avoid printing that message by checking if port node exists in PHY node > > before calling of_graph_get_remote_node(). > > By some reason you have two separate messages (missed --thread when run `git > format-patch ...`?). > > In any case I think it should be dropped or reworked and resent since patch 1/2 > got comments. > Yep, the patch version bit shouldn't be there, just forgot to remove it after `git format-patch'. So this is not a series, just two separate patches, and 2/2 was just dropped. Anyway, I'll resend this one soon, to remove the confusing versioning part. Thanks! > -- > With Best Regards, > Andy Shevchenko > >
