On Thu, Nov 26, 2020 at 11:34:33AM +0800, Longfang Liu wrote: > The system goes to suspend when using USB audio player. This causes > the USB device continuous send interrupt signal to system, When the > number of interrupts exceeds 100000, the system will forcibly close > the interrupts and output a calltrace error. This description is very confusing. USB devices do not send interrupt signals to the host. Do you mean that the device sends a wakeup request? Or do you mean something else? > When the system goes to suspend, the last interrupt is reported to > the driver. At this time, the system has set the state to suspend. > This causes the last interrupt to not be processed by the system and > not clear the interrupt state flag. This uncleared interrupt flag > constantly triggers new interrupt event. This causing the driver to > receive more than 100,000 interrupts, which causes the system to > forcibly close the interrupt report and report the calltrace error. If the driver receives an interrupt, it is supposed to process the event even if the host controller is suspended. And when ehci_irq() runs, it clears the bits that are set in the USBSYS register. Why is your system getting interrupts? That is, which bits are set in the USBSTS register? > so, when the driver goes to sleep and changes the system state to > suspend, the interrupt flag needs to be cleared. > > Signed-off-by: Longfang Liu <liulongfang@xxxxxxxxxx> > --- > drivers/usb/host/ehci-hub.c | 5 +++++ > 1 file changed, 5 insertions(+) > > diff --git a/drivers/usb/host/ehci-hub.c b/drivers/usb/host/ehci-hub.c > index ce0eaf7..5b13825 100644 > --- a/drivers/usb/host/ehci-hub.c > +++ b/drivers/usb/host/ehci-hub.c > @@ -348,6 +348,11 @@ static int ehci_bus_suspend (struct usb_hcd *hcd) > > /* Any IAA cycle that started before the suspend is now invalid */ > end_iaa_cycle(ehci); > + > + /* clear interrupt status */ > + if (ehci->has_synopsys_hc_bug) > + ehci_writel(ehci, INTR_MASK | STS_FLR, &ehci->regs->status); This is a very strange place to add your new code -- right in the middle of the IAA and unlink handling. Why not put it in a more reasonable place? Also, the patch description does not mention has_synopsys_hc_bug. The meaning of this flag has no connection with the interrupt status register, so why do you use it here? > + > ehci_handle_start_intr_unlinks(ehci); > ehci_handle_intr_unlinks(ehci); > end_free_itds(ehci); Alan Stern
