From: Peter Chen <peter.chen@xxxxxxx> [ Upstream commit 18a367e8947d72dd91b6fc401e88a2952c6363f7 ] If the xhci-plat.c is the platform driver, after the runtime pm is enabled, the xhci_suspend is called if nothing is connected on the port. When the system goes to suspend, it will call xhci_suspend again if USB wakeup is enabled. Since the runtime suspend wakeup setting is not always the same as system suspend wakeup setting, eg, at runtime suspend we always need wakeup if the controller is in low power mode; but at system suspend, we may not need wakeup. So, we move the judgement after changing wakeup setting. [commit message rewording -Mathias] Reviewed-by: Jun Li <jun.li@xxxxxxx> Signed-off-by: Peter Chen <peter.chen@xxxxxxx> Signed-off-by: Mathias Nyman <mathias.nyman@xxxxxxxxxxxxxxx> Link: https://lore.kernel.org/r/20200918131752.16488-8-mathias.nyman@xxxxxxxxxxxxxxx Signed-off-by: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx> Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx> --- drivers/usb/host/xhci.c | 7 +++++-- 1 file changed, 5 insertions(+), 2 deletions(-) diff --git a/drivers/usb/host/xhci.c b/drivers/usb/host/xhci.c index f4cedcaee14b3..4cfb95104c26b 100644 --- a/drivers/usb/host/xhci.c +++ b/drivers/usb/host/xhci.c @@ -982,12 +982,15 @@ int xhci_suspend(struct xhci_hcd *xhci, bool do_wakeup) xhci->shared_hcd->state != HC_STATE_SUSPENDED) return -EINVAL; - xhci_dbc_suspend(xhci); - /* Clear root port wake on bits if wakeup not allowed. */ if (!do_wakeup) xhci_disable_port_wake_on_bits(xhci); + if (!HCD_HW_ACCESSIBLE(hcd)) + return 0; + + xhci_dbc_suspend(xhci); + /* Don't poll the roothubs on bus suspend. */ xhci_dbg(xhci, "%s: stopping port polling.\n", __func__); clear_bit(HCD_FLAG_POLL_RH, &hcd->flags); -- 2.25.1
