If the xhci-plat.c is the platform driver, after the runtime pm is enabled, the xhci_suspend is called if nothing is connected on the port. When the system goes to suspend, it will call xhci_suspend again if USB wakeup is enabled. Since the runtime suspend wakeup setting is not always the same with system suspend wakeup setting, eg, at runtime suspend, we always need wakeup if the controller is in low power mode; but at suspend system, we may not need wakeup. So, we move the judgement after changing wakeup setting. Reviewed-by: Jun Li <jun.li@xxxxxxx> Signed-off-by: Peter Chen <peter.chen@xxxxxxx> --- drivers/usb/host/xhci.c | 7 +++++-- 1 file changed, 5 insertions(+), 2 deletions(-) diff --git a/drivers/usb/host/xhci.c b/drivers/usb/host/xhci.c index 3c41b14ecce7..cde71f3b9767 100644 --- a/drivers/usb/host/xhci.c +++ b/drivers/usb/host/xhci.c @@ -982,12 +982,15 @@ int xhci_suspend(struct xhci_hcd *xhci, bool do_wakeup) xhci->shared_hcd->state != HC_STATE_SUSPENDED) return -EINVAL; - xhci_dbc_suspend(xhci); - /* Clear root port wake on bits if wakeup not allowed. */ if (!do_wakeup) xhci_disable_port_wake_on_bits(xhci); + if (!HCD_HW_ACCESSIBLE(hcd)) + return 0; + + xhci_dbc_suspend(xhci); + /* Don't poll the roothubs on bus suspend. */ xhci_dbg(xhci, "%s: stopping port polling.\n", __func__); clear_bit(HCD_FLAG_POLL_RH, &hcd->flags); -- 2.17.1
