Hi Heikki, Sure. Same as the other patch I will try to address your question here and will update the commit description once you are satisfied with the description. Subject: During PR_SWAP, source caps should be sent only after tSwapSourceStart Commit description: The patch addresses the compliance test failures while running TD.PD.CP.E3, TD.PD.CP.E4, TD.PD.CP.E5 of the "Deterministic PD Compliance MOI" test plan published in https://www.usb.org/usbc. For a product to be Type-C compliant, it's expected that these tests are run on usb.org certified Type-C compliance tester as mentioned in https://www.usb.org/usbc. The purpose of the tests TD.PD.CP.E3, TD.PD.CP.E4, TD.PD.CP.E5 is to verify the PR_SWAP response of the device. While doing so, the test asserts that Source Capabilities message is NOT received from the test device within tSwapSourceStart min (20 ms) from the time the last bit of GoodCRC corresponding to the RS_RDY message sent by the UUT was sent. If it does then the test fails. This is in line with the requirements from the USB Power Delivery Specification Revision 3.0, Version 1.2: "6.6.8.1 SwapSourceStartTimer The SwapSourceStartTimer Shall be used by the new Source, after a Power Role Swap or Fast Role Swap, to ensure that it does not send Source_Capabilities Message before the new Sink is ready to receive the Source_Capabilities Message. The new Source Shall Not send the Source_Capabilities Message earlier than tSwapSourceStart after the last bit of the EOP of GoodCRC Message sent in response to the PS_RDY Message sent by the new Source indicating that its power supply is ready." The patch makes sure that TCPM does not send the Source_Capabilities Message within tSwapSourceStart(20ms) by transitioning into SRC_STARTUP only after tSwapSourceStart(20ms). Thanks, Badhri On Thu, Aug 13, 2020 at 1:25 AM Heikki Krogerus <heikki.krogerus@xxxxxxxxxxxxxxx> wrote: > > Hi, > > > This fixes TD.PD.CP.E3, TD.PD.CP.E4, TD.PD.CP.E5 failures > > I'm sorry, but that statement is way too cryptic. You really need to > explain what those are. > > thanks, > > -- > heikki
