From: Yasushi Asano <yasano@xxxxxxxxxxxxxx> According to 6.7.22 A-UUT “Device No Response” for connection timeout of USB OTG and EH automated compliance plan v1.2, the enumeration failure has to be detected within 30 seconds. However, the old and new enumeration schemes made a total of 16 attempts, and each attempt can take 5 seconds to timeout, so it failed with PET test. Modify it to reduce the number of attempts to 5 and pass PET test. in case of old_schene_first=N and use_both_schemes=Y attempt 3 * new scheme, then 2 * old scheme in case of old_schene_first=Y and use_both_schemes=Y attempt 2 * old scheme, then 3 * new scheme Signed-off-by: Yasushi Asano <yasano@xxxxxxxxxxxxxx> --- drivers/usb/core/hub.c | 16 +++++++--------- 1 file changed, 7 insertions(+), 9 deletions(-) diff --git a/drivers/usb/core/hub.c b/drivers/usb/core/hub.c index 052d5ac..5b15278c 100644 --- a/drivers/usb/core/hub.c +++ b/drivers/usb/core/hub.c @@ -2706,7 +2706,6 @@ static unsigned hub_is_wusb(struct usb_hub *hub) #define PORT_RESET_TRIES 5 -#define SET_ADDRESS_TRIES 2 #define GET_DESCRIPTOR_TRIES 2 #define SET_CONFIG_TRIES (2 * (use_both_schemes + 1)) #define USE_NEW_SCHEME(i, scheme) ((i) / 2 == (int)(scheme)) @@ -4539,7 +4538,7 @@ hub_port_init(struct usb_hub *hub, struct usb_device *udev, int port1, struct usb_device *hdev = hub->hdev; struct usb_hcd *hcd = bus_to_hcd(hdev->bus); struct usb_port *port_dev = hub->ports[port1 - 1]; - int retries, operations, retval, i; + int retries, retval, i; unsigned delay = HUB_SHORT_RESET_TIME; enum usb_device_speed oldspeed = udev->speed; const char *speed; @@ -4684,7 +4683,7 @@ hub_port_init(struct usb_hub *hub, struct usb_device *udev, int port1, * 255 is for WUSB devices, we actually need to use * 512 (WUSB1.0[4.8.1]). */ - for (operations = 0; operations < 3; ++operations) { + if (!((retry_counter % 2 != 0) && (retries != 0))) { buf->bMaxPacketSize0 = 0; r = usb_control_msg(udev, usb_rcvaddr0pipe(), USB_REQ_GET_DESCRIPTOR, USB_DIR_IN, @@ -4714,7 +4713,10 @@ hub_port_init(struct usb_hub *hub, struct usb_device *udev, int port1, retries == 0 && udev->speed > USB_SPEED_FULL)) break; + } else { + break; } + udev->descriptor.bMaxPacketSize0 = buf->bMaxPacketSize0; kfree(buf); @@ -4744,12 +4746,8 @@ hub_port_init(struct usb_hub *hub, struct usb_device *udev, int port1, * authorization will assign the final address. */ if (udev->wusb == 0) { - for (operations = 0; operations < SET_ADDRESS_TRIES; ++operations) { - retval = hub_set_address(udev, devnum); - if (retval >= 0) - break; - msleep(200); - } + retval = hub_set_address(udev, devnum); + msleep(200); if (retval < 0) { if (retval != -ENODEV) dev_err(&udev->dev, "device not accepting address %d, error %d\n", -- 2.7.4